LOG PLACEMENT GUIDE

750,158M

REV. N/C 05/2003
EDV3530, EDV4035 AND EDV4540 SERIES

LOG PLACEMENT GUIDE FOR LENNOX DIRECT VENT EDV3530, EDV4035

AND EDV4540 SERIES VENTED GAS FIREPLACE HEATERS

GENERAL INFORMATION

This log placement guide has been prepared to present detailed log placement illustrations and provide instruction to assist in the placement of logs at the initial (new appliance) setup and after the annual cleaning and inspection cycles. The information provided here is to be used in conjunction with the Homeowner's Care and Operation Instructions provided together with this document in the appliance literature packet. Please read the Homeowner's Care and Operation In-

structions completely before completing the procedures detailed in Figure 1 this placement guide.

INITIAL INSTALLATION CONSIDERATIONS

If the logs are being installed for the first time, the following paragraphs apply:

DO NOT attempt to install the logs until the appliance installation has been completed, the gas line connected and tested for leaks and the initial burner operation has been checked out.

Step 1. Remove the appliance front door.

Step 2. Remove the boxed log set from the interior of the firebox. Remove the logs from their packaging. Handle logs carefully to prevent breakage.

CERAMIC EMBER PANELS, LOGS AND GLOWING EMBER PLACEMENT

Step 1. Install the Ceramic Ember Panels as shown in Figure 3. Panels should be placed in the order shown.

A.Place the left and right panel against the corners as shown.

B.Align the two front legs of the grate assembly on the dimples and align the two rear legs between the cut out as shown.

C.Place the front panel into its proper position as shown. Adjust the panels to minimize the gaps.

Note: This appliance is provided with enough Glowing Embers for several applications, do not feel compelled to use all that is in a new bag. For best glowing effect, replace the ember material annually. Replacement Glowing Embers are available (Catalog Number 88L53).

Step 2. Position the individual logs as shown in Figures 4 and 5. Logs should be placed in the order shown. All logs that have notches to fit over the grate tines should be positioned with these notches directly against the grate.

Glowing Embers

Figure 2

Proper log placement is critical to encourage outstanding flame appearance and prevent sooting. When positioned properly as shown, logs will be positioned between flame peaks and will not impinge any flames.

Step 3. Separate the Glowing Ember (Rockwool) into pieces about the size of a quarter Figure 1. Keep the pieces fluffed up, not matted. Distribute these pieces over the front surface of the burner, as shown in Figure 2. Do not use more than is necessary. When properly posi- tioned, the Glowing Embers will cover approximately 65% of the front burner and with no appreciable gaps or openings. Ensure that the main burner ports remain uncovered by the ember material.

Refer to page 3 for EDV3530 Series appliances and to page 4 for EDV4035 & EDV4540 Series appliances.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.