Step 2. Using a 5/16" socket or nutdriver, remove the existing lintel as shown in Figure 3. Retain the screws for Step 3.
Lintel
Figure 3 - Removing Lintel
Step 3.Install the new lintel provided using the screws that were removed in step 2 (reversing instructions in step 2 and see Figure 3).
Step 4. Install the eyebrow as follows:
Note: Three holes must be drilled in the fireplace to install the eyebrow. When the eyebrow is properly aligned to the appliance, drill into the holes on the eyebrow and into fireplace.
1.Align the eyebrow provided as shown in Figure 4. Ensure that the eyebrow is pushed in flush to the fireplace front.
2.Drill into fireplace through the center hole on eyebrow.
3.Install a screw (provided) into the center hole on eyebrow into hole that you drilled. Repeat this process for the other 2 holes on eyebrow using the other 2 screws provided. See Figure 5.
Ensure Eyebrow is pushed in flush to fireplace front.
Eyebrow
Figure 4 - Installing Eyebrow
Eyebrow Mounting Holes
Drill through the center mounting hole first, then install screw. Repeat this process for the other 2 holes.
Figure 5 - Installing Eyebrow
Step 5. Reinstall glass door per instructions in Homeowner's Manual and per Step 1 and Figure 1.
Eyebrow
Lintel
Figure 6 - Completed Installation
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
LHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult your local distributor for fireplace code information.
LHP
Printed in U.S.A. © 2006 by LHP | 1110 West Taft Avenue |
P/N 750,235M REV. NC 08/2006 | Orange, CA 92865 |