Lennox Hearth H5820, 4.5HTSK installation instructions P/N 750,246M REV. B 04/2008

Step 4. Re-tighten the four (4) screws into place, securing the shroud body over the termination.

Step 5. Position the shroud top over the shroud body and screw it into the flanges located on both the shroud top and shroud body, using five (5) screws (as shown Figure 1 ).

Note: The five (5) screws are to be attached from the bottom.

Step 6. Attach the bottom screen onto the body of the shroud, using the three (3) screws into each of the three flanges on the shroud body (see Figure 1 ).

Step 7. If desired, paint shroud to any color.

Termination	Termination
Shroud - Top
Screw Flanges
(Five Places)
Securing Screws
(Five) For Shroud
Body To Shroud Top.
Install From The
Bottom Up.
Termination
Shroud - Body
	Back Off These Two Screws
	(Both Sides) And Slide
	Shroud Body Into Place.
	Securing Screws
Bottom Screen	(Three) For Bottom
	Screen To Shroud Body.
	Install From The Bottom Up.
Figure 1

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information.

Printed in U.S.A. © 2007 by LHP	1110 West Taft Avenue
P/N 750,246M REV. B 04/2008	Orange, CA 92865