6
FINAL FINISHING
Materials such as brick and tile can be extended down to the top of the fireplace. Do not extend down, covering the outlet or glass enclosure panel (optional kit).
There are a wide variety of “finished looks” for these fireplaces, from formal wall decor with elaborate mantels to rustic wood paneling or warm brick facings.
Mantel Cabinet or Accent Trim Installations
An optional mantel cabinet kit or an accent trim kit is available from your dealer (see page 18). These options give the appliance an attractive finished look.
Hearth
An aesthetically pleasing fireplace hearth can be installed, if desired (see hearth protection on page 5).
BREAK-IN PERIOD:
During the first few initial uses of this heater, there may be a release of a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not reoccur.
MANUAL CONTROL PANEL OPERATION
(refer to Figures 5 & 6)
Once this appliance has been properly installed and connected to the power supply as defined in this manual, it is ready to operate.
Note: Ensure the circuit breakers for the power supply are turned on.
This appliance can be operated either from the manual control panel (see Figures 4 & 5) or by using the remote control, wall switch or wall thermostat (optional kits).
The manual controls are located on the firebox floor on the front left (see Figure 5). If an optional glass enclosure is installed, it must be removed to access.
Main Power ON/OFF Switch
When the main power switch is turned on, power is supplied to the fireplace. This switch must be on for all other switches to operate.
Heater ON/OFF Switch
When this switch is turned on, the heater will emit heat in the temperature range selected (see Figure 6; G, H & I). The fireplace can operate with or without heat.
Flame / Ember On/Off Switch:
Turns lights on inside ember bed and flame cylinder.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
MANUAL CONTROL PANEL
Main Power On/Off (rear most switch)
OnOff
Heater On/Off (center switch)
OnOff
Flame / Ember On/Off (front most switch)
OnOff
Figure 4
Manual Control Switches are located behind pull screen on inside floor
Figure 5
•When using the main power on/off switch inside the body, the power on/off switch outside the body (optional wall switch kit) must be in the OFF position.
•When using power on/off switch outside the body (optional wall switch), the power on/off switch inside the body must be in the OFF position.
•When using the remote control, the power on/off switch inside the body and the wall switch (optional kit) must be on the OFF position.
