Lennox Hearth WARRANTY, WIRING DIAGRAMS, REPLACEMENT PARTS, PRODUCT REFERENCE INFORMATION, Pilot, Figure, Nozzle, Ground, Igniter, Electrode, ELECTRONIC, Adjustment

Electronic Appliance Checkout

To light the burner, refer to the lighting instructions on page 14 and 15. Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 10

ELECTRONIC

Proper Flame	3/8 To 1/2 Inch
	(9 mm to 13 mm)
Adjustment
Pilot
Nozzle	Ground
	Electrode
	Flame Rod
	Hot Surface
	Igniter

Figure 10

With proper care and maintenance, your appliance will provide many years of enjoyment. If you should experience any problem, first refer to the trouble shooting guide in this manual. If problem persists, contact your Lennox distributor.

WIRING DIAGRAMS

Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on a pullout panel located within

Electronic Wiring Diagram (Honeywell)Showing the Blower Wiring for the OptionalFBK-100 and FBK-200 Kits

1.If any of the original wire as supplied must be replaced, it must be replaced with Type AWM 105° C – 18 GA. wire.

2.120V, 60Hz – Less than 3 amps.

**ON/OFF Switch (Integral		**Leave the ON/OFF switch, which is integral
with Gas Valve)		with the gas valve, in the ON position.
	Gas Valve	PILOT
	IGNITER	ASSEMBLY
BK
	R	Green
	BL		White	Ground - Green
				Neutral - White
	OPT		Black	120 VAC - Black
	BLOWER			Junction Box
	Tab Intact
			Tab
			Broken
			Red	Optional
	Green
		Neutral	Hot	Accessory
	Ground	Side of	Side of	Switch
	Screw	Receptacle	Receptacle

W

BTransf.

	G	120 V.
BL		24 V
		R

W

BK

OPTIONAL APPLIANCE-MOUNTED ON/OFF SWITCH

OR OPTIONAL WALL SWITCH

OR OPTIONAL THERMOSTAT

OR OPTIONAL REMOTE RECEIVER

*Blower speed control switch is provided in FBK200 blower kit.

Factory Wired Field Wired

Schematic Representation Only

Electronic Wiring Diagram (Honeywell)

Showing the Blower Wiring for the Optional

FBK-250 Kits

1.If any of the original wire as supplied must be replaced,

1.it must be replaced with Type AWM 105° C – 18 GA. wire.

2.120V, 60Hz – Less than 3 amps.

*Leave the ON/OFF switch, which is integral

*ON/OFF Switch (Integral with the gas valve, in the ON position. with Gas Valve)

	Gas Valve		PILOT	Ground - Green
			ASSEMBLY
		IGNITER		Neutral - White
BK				120 VAC - Black

Optional

RFBK-250

BL	Module	Green	White
OPT			Black
BLOWER				Junction Box
	Tab Intact		Tab
			Broken
	Green		Red	Optional
		Neutral	Hot	Accessory
	Ground
	Screw	Side of	Side of	Switch
		Receptacle	Receptacle

W

BTransf.

G 120 V.

BL	24 V
	R

WH

BK

OPTIONAL APPLIANCE-MOUNTED ON/OFF SWITCH OR OPTIONAL WALL SWITCH OR OPTIONAL THERMOSTAT

OR OPTIONAL REMOTE RECEIVER

Factory Wired Field Wired

Schematic Representation Only

the control compartment.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS APPLIANCE OPERATION.

Millivolt Wiring Diagram

If any of the original wire as supplied must be replaced, it must be replaced with Type AWM 105° C – 18 GA. wire.

TP	TH TP
	TH

Thermopile

Retain this manual. File it with your other documents for future reference.REPLACEMENT PARTS

A complete parts list is found at the end of this manual. Use only parts supplied from the manufacturer.

Normally, all parts should be ordered through your Lennox distributor or dealer. Parts will be shipped at prevailing prices at time of order.

When ordering repair parts, always give the following information:

1.The model number of the appliance.2.The serial number of the appliance.3.The part number.4.The description of the part.5.The quantity required.6.The installation date of the appliance.

If you encounter any problems or have any questions concerning the installation or application of this system, please contact your dis- tributor, or Lennox directly:

LENNOX HEARTH PRODUCTS1110 West Taft Avenue • Orange, CA 92865

Field Wired

Factory Wired

APPLIANCE-MOUNTED ON/OFF SWITCH

*OPTIONAL WALL-MOUNTED ON/OFF

SWITCH OR OPTIONAL THERMOSTAT

*Turn the appliance-mounted ON/OFF burner control switch to the OFF position if an optional control switch is installed.

Schematic Representation Only

WARRANTY

Your gas appliance is covered by a limited twenty year warranty. You will find a copy of the warranty accompanying this manual. Please read the warranty to be familiar with its coverage.

8

PRODUCT REFERENCE INFORMATION

We recommend that you record the following important information about your fireplace. Please contact your Lennox dealer for any questions or concerns. For the number of your nearest Lennox dealer, please call 1-800-9-LENNOX.

Your Fireplace's Model Number _______________________________________Your Fireplace's Serial Number ________________________________________The Date On Which Your Fireplace Was Installed __________________________The Type of Gas Your Fireplace Uses ___________________________________Your Dealer's Name _________________________________________________

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.