2
Printed in U.S.A. © 2011 Lennox hearth Products
P/N 506033-56 Rev. NC 08/2011
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Lennox Hearth Products reserves the right to make changes at any time, without notice, in
design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
Step 3. Install the four supplied allen screws into tinnerman nuts, leaving
loose. A 1/8” allen wrench will be necessary.
Step 4. Place blower keyhole mounting slots onto the four installed screws
and slide assembly downward, ensuring all mounting screws are
holding blower in place. Tighten all four screws snugly. NOTE*
POWER CORD WILL BE ON THE BOTTOM.
Step 5. Install temperature activated switch bracket into rectangle cutout,
in the upper right corner on rear of stove, with wires facing out-
ward from the actual firebox. Secure with the larger two supplied
allen head screws. A 5/32” allen wrench will be necessary. NOTE*
ENSURE TEMPERATURE ACTIVATED SWITCH IS MAKING FIRM,
FLAT CONTACT WITH SIDE OF FIREBOX.
Step 6. Plug power cord into 120V wall outlet.
Figure 2 - Installed Blower w/ Snap SwitchBLOWER OPERATION
The blower can be operated in either manual or automatic mode. When
operated automatically, the blower will turn on when the stove is hot, and
turn off when the stove is cool.
MANUAL OPERATIONFlip blower mode switch to the manual position (up) and adjust blower
speed dial to desired setting. to turn blower off, rotate blower speed dial
counter clockwise until it clicks “OFF”.
AUTO OPERATIONFlip blower mode switch to auto position and turn blower speed dial
clockwise until it clicks out of the “off” position. When the stove warms
up (approx. 15-20 Mins), the blower will automatically turn on (adjust
blower speed dial to desired speed setting. When the stove cools down,
the blower will automatically turn off.
Figure 3 - Blower Controls1508 Elm hill Pike, Suite 108 • Nashville, TN 37210