13
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
5. If required, install the Outside Air Kit (cat. no. 71112) as per the
following instructions. To locate the hole in the hearth for outside
air mark and cut a 4” (102 mm) hole in the hearth. The hole’s
center should be 3” (76 mm) directly forward from the center
of the flue outlet or locate as per the instructions below.
6. Position the stove on your floor protection in the exact location
where it is to be located, making sure all minimum clearances
are met. Mark the floor protection where the pedestal will be
located, then remove the stove.
7. Make four 1-1/2” (38 mm) cuts in one end of the corrugated
tube and fold the flaps back. Cut a 4” (102 mm) hole through
the floor protection and the floor and insert the corrugated tube
into the hole. Cover it with the supplied screen and fasten it to
the floor protector.
8. Locate the 11-1/2” x 14” (292 mm x 356 mm) metal plate and
paint to match the stove if necessary. Position this piece so that
the 14” (356 mm) dimension evenly overlaps the lips on the back
of the pedestal (see drawing below). Attach this plate to the back
of the pedestal with the self-tapping screws supplied.
9. If the stove is to be fastened to the floor, attach the stove with
the supplied lag bolts, through the pedestal base on opposite
sides, attaching them into the floor beneath the floor protection.
Seal any irregularities with silicone sealer.
10. If installed in a mobile home, the heater shall be grounded to
the chassis with a #8 AGW copper wire or equivalent.
11. Install bricks as per instructions on Pages 14 and 15. It is highly
recommended that the baffle be assembled before the chimney
is installed so that the baffle blanket can be adjusted into place
from the flue outlet.
12. Install chimney as per manufacturer’s instructions.
(For ash drawer pedestal see instructions included with pedestal)
Residential and Mobile Homes
(Bolting down and grounding are required only in mobile homes)
CAUTION: Wear gloves during installation in case of sharp edges on the stove.
1. Remove the heater from the carton, if packaged, upon receipt
and check for any damaged or missing parts.
2. Carefully put the stove on pedestal with the open end of the pedestal
facing the rear. DO NOT LEAVE THE STOVE UNATTENDED
UNTIL IT IS BOLTED SECURELY TO THE PEDESTAL.
3. Line up the holes in the brackets on the pedestal with the threaded
holes in the bottom of the stove. Use the two 1/2” long bolts
and 3/8” standard washers to bolt the stove to the pedestal. Be
sure to see that the stove is mounted squarely on the pedestal
before tightening the two bolts securely.
4. When installing a pedestal on this stove you MUST plug the four
leg mounting bolt holes, located on the bottom of the stove in
the four corners, with the bolts that were used to mount the
shipping legs. The two rear bolts should not be installed more
than two full rotations to prevent lifting the bricks off the bottom
of the stove. FAILURE TO INSTALL THESE FOUR BOLTS
PROPERLY WILL RESULT IN REDUCED CONTROL OF THE STOVE’S COMBUSTION SYSTEM!Figure 13PEDESTAL INSTALLATION
Block Off Plate is
Required When
Installing Outside
Air Into Unit (Plate
is Included With
Kit # 71112)