11
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
PosT insTallaTion checks
1. Check that all chimney pipe joints are securely fas-
tened.
2. Check that the heater is securely fastened to the floor
(if applicable).
3. Make sure the intake vent has clear access to outside
air (if applicable).
4. Make sure the outside air vent has been sealed properly
to keep rodents out (if applicable).
5. Be sure all roof flashings are watertight.
6. Be sure the stove is properly grounded (if applicable).
FOR YOUR OWN PROTECTION AND INSURANCE PUR-
POSES, HAVE YOUR CHIMNEY AND CONNECTOR PIPE
INSTALLATION INSPECTED BY YOUR LOCAL BUILDING
CODE AUTHORITY OR FIRE MARSHAL BEFORE START-
ING A FIRE IN YOUR STOVE. NOTIFY YOUR INSURANCE
COMPANY.
Brick insTallaTion
Caution: Wear gloves during brick installation in case
of sharp edges inside the stove.
Note: Installation of the baffle bricks and insulating blanket
is easier when you can still access the flue outlet, (before
connecting the flue pipe). Be sure the insulating blanket
is placed flat on the bricks so as not to block the flue. Use
a ruler or a piece of kindling to reach over the blanket to be
sure it is completely flat on top of the baffle bricks.
Measure bricks before installing, as per list of dimensions
on next page, to be sure the correct bricks are installed in
the correct location.
1. Install bricks #1-34 in the numbered sequence shown in
FIGURE 1 on the following page. (Note: Bricks # 22-25
lean up against the lower air channel and butt against
bricks #17-21 on the bottom of the stove.
Note: Before installing your baffle bricks make sure the
stainless steel tube support and front and rear tube
hangers are centered side to side and that the front
and rear hangers are hooked onto the stainless steel
pins protruding from the rear of the airwash and the
stove back.
2. Next install bricks #35-40 on top of the stainless steel
secondary burn tubes in the upper part of the firebox.
These bricks fit up against bricks #26-30 on the backwall
and should rest on the rear two stainless steel second-
ary tubes. Thes two sets of three bricks go either side
of the stainless steel secondary tube support running
front to rear down the center of the stove.
3. Be sure the stainless steel tube support is in the center,
as shown, and that its two stabilizer pieces in the front
and the rear are attached to the two hooks welded to
the firebox front and rear.
4. Included with the stove are two 13”x 17-1/2”x 1” thick
ceramic fiber blankets. Install a ceramic fiber blanket on
top of each set of three bricks, making sure the blankets
are pushed fully to the rear.
5. Next, install the front baffle bricks #41-46 under the
ceramic fiber blanket and on top of the front two stain-
less steel secondary tubes. (CAUTION: Make sure that
the ceramic fiber blankets are centered side to side and
rest flat on the baffle bricks and do not project forward
beyond the front of the baffle bricks #41-46).