Lennox Hearth TAPD35ESP, TAPD45SP, TAPD35SP, TAPD40SP, TAPD45C, TAPD35C, TAPD35EC For Edvst Model Only

For EDVST Model Only

Adjust Doorframe Bracket

Step 1 - Remove the two #8 screws from the bracket screw cover on both sides.

Step 2 - Remove the two #10 screws from the firebox bottom on both sides (save screws).

Bracket

Screw

Cover

#8

Screw

#10 Screw

Locate the doorframe bracket on the lower front of the doorframe and lock it behind the cabinet bottom flange as shown here.

Doorframe

Bracket

Figure 7

7.Remove the screen doors from packaging. Install them by aligning hinge pins on the doors with the hinge holes on the doorframe and slide down (see instructions in Figure 8). Ensure the hinge pins are fully seated onto the shoulders of the hinge holes.

Step 3 - Install the Firebox Bottom Cover Panel (#5 in Figure 1) using the existing #10 screws. The bottom two holes on the cover panel align to cor- responding two holes on firebox bottom.

Figure 5b - Install Firebox Cover

4.For EDV, EDVST & EBVST models, reinstall modesty panel, ensuring all wires are securely connected.

5.Install Doorframe (see Figure 6) - Remove the arched doorframe from packaging. Position the top of the doorframe above the top of the glass doorframe (centered and approximately 1” above the top of the glass doorframe). Slide down so that the hooks catch on the back of the doorframe slide between the sides of the glass door and the corner posts engaging into existing slots on fireplace.

	Doorframe
	Right
Left	Corner
Corner	Post
Post

Firebox

Align hinge pins on the doors with the hinge holes on the doorframe and slide down as shown.

Hinge Pin

Figure 6 - INSTALL DOORFRAME

6.Place the doorframe bracket in the locked position as shown in Figure 7.

Firebox

Figure 8

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

3