Lennox Hearth view door CAUTION, INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD, INSTALLATION INSTRUCTIONS:, P/N 775,169M REV. B 06/2006, Bustles, Louvers, Doorframe, Slot, Figure

CAUTION

INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!

INSTALLATION INSTRUCTIONS:

1.Remove top louver or radiant panel/hood assembly (if possible), by pulling the assembly up and out (see Figure1). In instances where the radiant panel is used but it is framed in with tile or other approved material, the hood must still be removed by firmly pulling it forward until it releases from the receiving brackets. If installing Style View doors on Elite units, remove top and bottom bustle by lifting them up and out. Merit Plus models are not equipped with bustles.

Bustles

Louvers

Figure 1

2.Ensure the glass door assembly on the fireplace is properly aligned as follows:

a.Open the bottom louver (hinges down).b.(For Elite-2 and EDV Models only)

i.Remove the bottom compartment door by sliding the hinge pin, located at the door’s left side, to the right un-til it disengages from the left corner post hole. Pull the door diagonally to the left, away from the fireplace.

ii.Remove the modesty panel as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or discon-nected.

c.Open both latches at the bottom of the glass door assembly (refer to Homeowners Manual).

d.Adjust glass door so that it is evenly spaced and aligned to the fireplace chassis on both sides.

e.Fasten the 2 latches (ensure that both latches are engaged with the door’s vee-flange and fully closed).

3.Remove Style View doorframe from packaging. Install the door-frame as follows:a.Locate slots on each side of fireplace (see Figure 2).

Doorframe

Slot

Slot

Figure 2

b. Position the top of the doorframe above the top of the glass door assembly (centered and approximately 1” above glass door assem- bly). Note: The bottom of the doorframe should be held slightly away as shown in Figure 2. Swing the bottom of the doorframe inward aligning the sides of the doorframe between the glass door and fireplace chassis and tabs on doorframe aligning into slots on fireplace. Swing the bottom of the doorframe in, then push down to ensure engagement.

4.Remove the Style View doors from packaging. Install them by aligning hinge pins on the doors with the hinge holes on the doorframe and slide down (see Figure 3). Ensure the hinge pins are fully seated onto the shoulders of the hinge holes.

Hinge Pins

Figure 3

5.Close both doors.

6.Ensure that both latches below the door are engaged with the door’s vee-flange and fully closed before operating the fireplace.

7.For Elite-2 and EDV models, reinstall modesty panel, ensuring all wires are securely connected.

8.Re-install the top louver assembly, hood or bustles, if applicable.9.Close the bottom louver assembly.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and the discontinuance of colors, styles and products. Consult your local distributor for fireplace code information.

Printed in U.S.A. © LENNOX HEARTH PRODUCTS 2003

P/N 775,169M REV. B 06/2006 Page 2 of 2 1110 West Taft Avenue • Orange, CA 92865