Lenovo S6000L manual Power system checkout, Checking the IdeaTab AC Charger

General checkout

Power system checkout

To verify a symptom, follow the steps below:

1.Turn off the computer.

2.Remove the battery pack.

3.Connect the AC adapter.

4.Make sure that power is supplied when you turn on the computer.

5.Turn off the computer.

6.Disconnect the AC adapter and install the charged battery pack.

7.Make sure that the battery pack supplies power when you turn on the computer.

If you suspect a power problem, see the appropriate one of the following power supply checkouts:

•“Checking the IdeaTab AC Charger” on page 21

•“Checking the internal battery status” on page 21

Checking the IdeaTab AC Charger

When you use the IdeaTab AC Charger to charge the tablet but no power is charged, see the instructions in this topic to check the IdeaTab AC Charger.

To check the IdeaTab AC Charger, do the following:

1.Disconnect the micro-USB cable from the tablet.

2.Measure the output voltage across the connector marked B of the micro-USB cable. Refer to the following figure:

1 2 3 (5V)

Pin Voltage (V dc)

1Ground

20

3+5

Note: The output voltage across pin 3 of the micro-B connector might be different from the one you are servicing.

3.If the voltage is not correct, replace the micro-USB cable.

4.If the voltage is acceptable, replace the system board.

Checking the internal battery status

To check the battery status of the tablet, do either of the following:

•Approximate information about the battery status

Get the approximate status of the battery at any time by checking the battery status icon on the system bar in the upper-right corner of the screen. The shorter the green bar is, the less the battery power remains.

•Accurate information about the battery status

To get the accurate information about the battery status of the tablet, do the following:

21