•
•Network interfaces support simultaneous communications via
•
•Included PowerAlert UPS monitoring software supports safe unattended shutdown, monitoring and control via local connected servers, plus any number of additional servers over IP
•UPS interface supports
monitoring, battery charge current, battery capacity, timed inverter shutoff, activate
•NEMA
•Dataline surge suppression protects dialup, DSL or network Ethernet connection
•Front panel LEDs offer current monitoring, voltage regulation and battery charge level information
•UPS ships fully assembled in full compliance with DOT regulations; no
•
SPECIFICATIONS
Output |
| Input |
| ||
Output Volt Amp Capacity (VA) | 750 | Rated input current | 5.4A (120V), 5.8A (110V), | ||
Output Watt Capacity (watts) | 500 | (at maximum load) | 6.4A (100V) | ||
|
|
| |||
Nominal Output Voltage(s) | 100V, 110V, 120V | Nominal input voltage(s) | 100V AC, 110V AC, 120V AC | ||
supported |
| ||||
Supported |
|
| |||
|
|
|
| ||
Frequency Compatibility | 60Hz | UPS input connection type | |||
|
|
| |||
Output Voltage Regulation | UPS input cord length (ft) | 6ft | |||
|
|
| |||
(line mode) |
| Recommended electrical | 120V, 15A | ||
8 | service |
| |||
|
|
| |||
Receptacles |
| Voltage compatibility (VAC) | 120 | ||
|
|
|
|
| |
Battery |
| Voltage Regulation |
|
| |
Full load runtime (minutes) | 10 minutes (500W) | Voltage regulation | Automatic Voltage | ||
Half load runtime (minutes) | 27 minutes (250W) | description | Regulation (AVR) circuits | ||
|
| maintain clean, regulated | |||
Expandable battery runtime | Runtime is expandable with |
|
| ||
|
| ||||
|
|
| |||
|
|
| 110, 100V nominal output, | ||
|
|
| |||
|
|
| without using battery | ||
| compatible) |
|
| ||
|
|
| power, during brownouts | ||
External battery pack | BP24V15RT2U |
|
| ||
|
| 95V (120V), 87V (110V), | |||
compatibility |
|
|
| 83V (100V) | |
DC System Voltage (VDC) | 24 | Overvoltage correction | Input voltages between 127V | ||
Battery recharge rate | Less than 4.5 hours from | ||||
|
| and 145V (120V), 116 and | |||
(included batteries) | 10% to 90% |
|
| 133 (110V), 111 and 121 | |
Replacement battery |
|
| (100V) are reduced by 12% | ||
|
|
| |||
cartridge (internal UPS |
| Undervoltage correction | Voltage boost of 14% | ||
battery replacement) |
|
|
| applies when input is 95 | |
Battery access | Supports battery access |
|
| – 108 (120V), 87 – 99 | |
| and |
|
| (110V), 83 – 90 (100V) | |
| without powering connected |
|
|
| |
| equipment off |
|
|
| |
|
|
|
|
| |
LEDs Alarms and Switches |
| Surge/Noise Suppression |
| ||
LED Indicators | 9 LEDs indicate line power, | UPS AC suppression joule | 570J | ||
| battery power, AVR, | rating |
| ||
| overload and replace battery | EMI/RFI AC noise | Yes | ||
| suppression |
| |||
| meter for load and battery |
| |||
| AC suppression response time | Instantaneous | |||
| charge level | ||||
| Dataline suppression | Includes | |||
Alarms | Audible alarm warns of | ||||
|
| pins 1, 2, 3 and 6 provide | |||
| power failure condition |
|
| ||
|
|
| 10baseT Ethernet line | ||
Switches | Includes two pushbutton |
|
| ||
|
| surge suppression with | |||
| switches for on/off power |
|
| ||
|
|
| 7.5V clamping; pins 4 and | ||
| control and |
|
| ||
|
|
| 5 provide | ||
| alarm cancel functions. |
|
| ||
|
|
| DSL line surge suppression | ||
| Also includes two dip switch |
|
| ||
|
|
| starting at 260V | ||
| controls for setting the |
|
| ||
|
|
|
| ||
| nominal voltage |
|
|
| |
|
|
|
|
|