WARNING
Do not set thermostat below 60°F (16°C) in heating mode. Setting thermostat below 60°F (16°C) reduces the number of heating cycles. Damage to the unit may occur that is not covered by the warranty.
WARNING
If overheating occurs or if gas supply fails to shut off, shut off the manual gas valve to the furnace before shutting off electrical supply.
WARNING
Do not use this furnace if any part has been under- water. A flood−damaged furnace is extremely dan- gerous. Attempts to use the furnace can result in fire or explosion. Immediately call a licensed pro- fessional service technician (or equivalent) to in- spect the furnace and to replace all gas controls, control system parts, and electrical parts that have been wet or to replace the furnace, if deemed neces- sary.
NOTICE
Any additions, changes, or conversions required in order for the appliance to satisfactorily meet the ap- plication needs must be made by a licensed profes- sional installer (or equivalent) using factory−speci- fied and approved parts.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause property damage, person- al injury or loss of life. Installation and service must be performed by a licensed professional installer (or equivalent), a service agency, or the gas supplier.
Safety Instructions
1 − Keep the furnace area clear and free of combustible material, gasoline, and other flammable vapors and liquids. If it is installed in an insulated area, the furnace must be kept free of insulating material. Insulating ma- terial may be combustible.
2 − After any heavy snow, ice or frozen fog event, the fur- nace vent pipes may become restricted. Always check the vent system and remove any snow or ice that may be obstructing the plastic intake or exhaust pipes.
3 − DO NOT obstruct air flow to unit. Unit must receive an unobstructed flow of combustion and ventilating air. DO NOT block or obstruct air openings on the furnace or air openings to the area in which the furnace is installed. Take care to maintain established clear- ances surrounding the furnace.
4 − DO NOT store chlorine or fluorine products near unit or introduce these products into the combustion air. These products can cause furnace corrosion.
5 − DO NOT draw return air from a room where this fur- nace, or any other gas appliance (ie., a water heat- er), is installed. When return air is drawn from a room, a negative pressure is created in the room. If a gas ap- pliance is operating in a room with negative pressure, the flue products can be pulled back down the vent pipe and into the room. This reverse flow of the flue gas may result in incomplete combustion and the formation of carbon monoxide gas. This toxic gas might then be distributed throughout the house by the furnace duct system.
WARNING
The blower door must be securely in place when the blower and burners are operating. Gas fumes, which could contain carbon monoxide, can be drawn into the living space resulting in personal injury or death.
Page 3
