Lenoxx Electronics CD-106 manual Choosing the power sources, Connecting the AC power cord

Choosing the power sources

You can use the AC power or batteries as a power source.

AC SOCKET

2. Battery compartment 1. To a wall outlet

Tip

The plug of the AC power cord is polarized and only fits one way into the wall outlet and back of the set.

If this plug does not match your outlet, do not force it. Reverse it and try again.

Tip

Replace the batteries when the Power/Batt. Lamp gets dim or when the player stops operating. Replace all the batteries with fresh ones. Before you replace the batteries, be sure to remove the CD from the player and remember to check the Battery Safety Instructions on Page 3.

1. Connecting the AC power cord

Insert one end of the supplied AC power cord to the socket located at the rear of the set, and the other end to the wall outlet.

2. Operate the set on batteries

Insert 8 size “C” batteries (not included) into the battery compartment.

To operate the set on batteries, disconnect the AC power cord from the player.

		c				c
LOWER			c				c		UPPER
				c				c
	c				c

14CD-106081199 AS v.1 E