![CHOOSING THE POWER SOURCES](/images/new-backgrounds/18437/184379x1.webp)
CHOOSING THE POWER SOURCES
You can use the AC power or batteries as a power source.
AC SOCKET | To a wall outlet |
NOTE: One blade of plug and outlet is wider.
Battery compartment
TIP
• If the plug of the AC |
power cord does not |
match your outlet, do not |
force it. |
Reverse it and try again. |
The plugs are polarized |
and only fits one way into |
the wall outlet and back |
of the set. |
• Replace the batteries |
when the POWER lamp |
dims or when the player |
stops operating. Replace |
all the batteries with new |
ones. Before you replace |
the batteries, be sure to |
take out the CD from the |
player and remember to |
1. Connecting the AC power cord
Insert one end of the supplied AC power cord (located in the battery compartment) into the socket located at the rear of the player, and the other end to the wall outlet.
2. Using the player on batteries
Insert 6 size “C” batteries (not supplied) into the battery compartment.
To use the player on batteries, disconnect and remove the AC power cord from the player.
upper | $ | # | Insert new batteries | |
|
| |||
upper | " | ! | according to sequence | |
as shown on FIG. 1. | ||||
| ||||
|
|
| ||
lower |
|
| ||
|
|
|
check the Battery Safety |
Instructions on Page 3. |
FIG. 1
+ | + |
+ | + |
FIG. 2
To remove the batteries, (open the door) stick your finger into the hole on the bottom of the set and push the batteries out as shown on FIG. 2.
4