PRECAUTIONS

On Safety

Should any solid object or liquid fall

into the set, disconnect the power, and

have it checked by qualified personnel

before operating it any further.

California Proposition 65 Warning:

Notes on Cassette

Break off the cassette tab from side A or B to prevent accidental recording. If you want to reuse the tape for recording, cover the broken tab with adhesive tape.

This product contains chemicals known

to the state of California to cause cancer,

and birth defects or other reproductive

harm.

Wash Hands After Handling.

On Placement

Do not leave the set in a location

Tab for side B

Side A

Tab for side A

near heat source, or in a place subject

to direct sunlight, excessive dust or

mechanical shock.

Do not place the set on an inclined

or unstable place.

Do not place anything within 1 inch of

the back of the cabinet. The ventilation

holes must be unobstructed for the

set to operate properly and prolong

the life of its components.

If the set is left in a car parked in

the sun, be sure to choose a location

in the car where the set will not be

subjected to the direct rays of the sun.

Since a strong magnet is used for the

speakers, keep personal credit cards

using magnetic coding or spring-

wound watches away from the set

to prevent possible damage from the

magnet.

On Power Sources

For battery operation, use 4 size “C” batteries. We recommend alkaline batteries for longer life.

When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion.

The nameplate indicating operating voltage, power consumption, etc. is located at the back of the set.

To record on a tape with its tab broken off, cover the respective tab hole for side A or B with adhesive tape.

Use of a cassette with more than 90 minutes, such as C-120 (120 minutes), is not recommended. The extreme thinness of this tape may damage this set.

To reduce the chances of tape jamming or tangling, you should check that there are no loose layers of tape visible through the cassette center window. If any, tighten these loose layers of tape using a pencil before inserting the cassette into the set.

10IB-CT992(NL)-WM-E-031103

Page 11
Image 11
Lenoxx Electronics CT-992 manual Precautions, On Safety, On Placement, On Power Sources