Lenoxx Electronics PH5435 , Step 2: Telephone Installation

IB-PH5435-WC-E-032805

Before you connect the phone cords, follow these steps to install

the batteries:

1.Push down the battery door tab with a pen or other pointed

object and lift the battery door out (Fig. 1).

2.Insert 3 size “AA” alkaline batteries as shown inside the

battery compartment (Fig. 2 & Fig. 3). (The negative side (–) of

the battery touches the battery spring.)

3.Replace the battery door and snap it shut (Fig. 4).

•When the batteries are dead, the display will not show

anything. You can still make or receive calls, but you can’t use

the Caller ID functions.

•If your batteries become completely drained, your caller ID data

and memories may be lost.

GETTING STARTED

Step 2: Telephone Installation

INSTALLING BATTERIES

5

CAUTION

Make sure that the telephone line cord is disconnected before

opening the battery door.

Replace the batteries when the LOW BATTERY INDICATOR

appears in the display or when the display gets dim.

Fig. 1 Fig. 2

Fig. 3 Fig. 4

IB-PH5435-WC-E-032805.pmd 4/1/2005, 12:28 PM7

Contents

Main TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS GENERAL FCC INFORMATION FCC REGISTRATION IMPORTANT FCC INFORMATION RINGER EQUIVALENCE NO. (REN) LOCATION OF CONTROLS Step 1: Checking the Package Contents Step 2: Telephone Installation INSTALLING BATTERIES CAUTION Make sure that the telephone line cord is disconnected before opening the battery door. ATTACHING THE DESK STAND Step 2: Telephone Installation (continued) CONNECTING THE TELEPHONE Step 3: Setting up the Telephone SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE, TIME & DATE, AND TONE OR PULSE MODE BASICS Making and Receiving Calls MAKING A CALL RECEIVING A CALL Volume Control and Ringer Setting MEMORY DIALING Storing Phone Number into Memory TO STORE A NUMBER TO BE DIALED VIA PRIVATE BRANCH EXCHANGE (PABX) TO CHANGE A STORED NUMBER Making Calls with One-Touch Speed Dial Buttons Making Calls with Two-Touch Speed Dial Locations Understanding the Caller ID Service When You Receive a Call Viewing the Caller ID List Calling back from the Caller ID List B. When Handset is Picked Up A. When Handset is on the Base Storing Phone Numbers from the Caller ID List Deleting the Data from the Caller ID List TO DELETE THE CALLER ID MEMORY ONE BY ONE ONLY TO DELETE ALL THE CALLER ID MEMORIES Using Message Waiting / Mailbox Note:You can delete the data either when the handset is on the base or it is picked up. WALL MOUNTING IMPORTANT WALL MOUNTING WITHOUT A MODULAR WALL PHONE PLATE Note: The base stand is not needed for wall mounting. TROUBLE SHOOTING CHECK PROBLEMS TROUBLE SHOOTING NOTE: (continued) PROBLEMS CHECK LIMITED WARRANTY For Customer Service