Manuals / Brands / Communications / Telephone / Lenoxx Electronics / Communications / Telephone

Lenoxx Electronics PH5435 Step 2: Telephone Installation (continued)

1 18

Download 18 pages, 342.18 Kb

IB-PH5435-WC-E-032805

GETTING STARTED

ATTACHING THE DESK STAND

Step 2: Telephone Installation (continued)

1.Insert the 4 raised tabs of the stand into the wider part of the

base slots.

2.Slide the stand up until it locks into place.

Step 1 Step 2

CONNECTING THE TELEPHONE

If your telephone outlet is not modular, contact your telephone

company for assistance.

3.Route the LINE CORD into the channel on the bottom of the

base.

1.Connect the COILED HANDSET CORD to the bottom of the

handset and the left side of the base (Step 1).

2.Connect the straight telephone line cord to the LINE CORD

jack on the bottom of the base unit and telephone outlet on the

wall (Step 2). (If you want to mount the telephone on the wall,

refer to Wall Mounting instruction of this booklet.)

Note: Connect cords before attaching the desk stand.

IB-PH5435-WC-E-032805.pmd 4/1/2005, 12:28 PM8

Contents

Main TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS GENERAL FCC INFORMATION FCC REGISTRATION IMPORTANT FCC INFORMATION RINGER EQUIVALENCE NO. (REN) LOCATION OF CONTROLS Step 1: Checking the Package Contents Step 2: Telephone Installation INSTALLING BATTERIES CAUTION Make sure that the telephone line cord is disconnected before opening the battery door. ATTACHING THE DESK STAND Step 2: Telephone Installation (continued) CONNECTING THE TELEPHONE Step 3: Setting up the Telephone SETTING UP LCD CONTRAST, LANGUAGE, AREA CODE, TIME & DATE, AND TONE OR PULSE MODE BASICS Making and Receiving Calls MAKING A CALL RECEIVING A CALL Volume Control and Ringer Setting MEMORY DIALING Storing Phone Number into Memory TO STORE A NUMBER TO BE DIALED VIA PRIVATE BRANCH EXCHANGE (PABX) TO CHANGE A STORED NUMBER Making Calls with One-Touch Speed Dial Buttons Making Calls with Two-Touch Speed Dial Locations Understanding the Caller ID Service When You Receive a Call Viewing the Caller ID List Calling back from the Caller ID List B. When Handset is Picked Up A. When Handset is on the Base Storing Phone Numbers from the Caller ID List Deleting the Data from the Caller ID List TO DELETE THE CALLER ID MEMORY ONE BY ONE ONLY TO DELETE ALL THE CALLER ID MEMORIES Using Message Waiting / Mailbox Note:You can delete the data either when the handset is on the base or it is picked up. WALL MOUNTING IMPORTANT WALL MOUNTING WITHOUT A MODULAR WALL PHONE PLATE Note: The base stand is not needed for wall mounting. TROUBLE SHOOTING CHECK PROBLEMS TROUBLE SHOOTING NOTE: (continued) PROBLEMS CHECK LIMITED WARRANTY For Customer Service