Assembly -
Always make sure the juicer is unplugged before beginning assembly.
1 Place the iuicebowl on top of the motor base Two tabs located on the underside of the iuicebowl should rest in two accompanying slots on top of the motor base. (The tabs and slots are by
each clamp.)
2.Set the blade/basket on the hub in the center of the juicebowl, and press down until it feels snug.
3 Gently rotate the blade/basket to ensure
that it turns freely. If initially it failed to seat, this should slip it into place Double check by pressing down and spinning
it again.
4 Place the clear cover over the iuicebowl with the large pulp ejection opening toward the back of the juicer.
5.Place the tops of the clamps on the respective slots on the cover, leaving the clamp hinges resting out. Press the bottom of the clamps in, until they snap snugly into place.
6.Place the pulp basket under the pulp spout behind the luicer.
