![](/images/new-backgrounds/1192124/19212419x1.webp)
Installing the Gigabit Ethernet Card
1.Shut down the computer, unplugs its power cord, and remove the chassis cover.
2.Insert the contact edge of the Gigabit Ethernet card into the connector of any available PCI Bus Master expansion slot. Press the card firmly into the connector such that the card’s contacts are fully seated in the connector, This card can put either in 32
3.Install the bracket screw which secures the card to the computer chassis.
4.Replace the computer’s chassis cover.
5.Reconnect the computer’s power cord, and switch computer power on. If the BIOS section of your computer’s boot program is Plug-
NOTE: Due to a fault in some
6