Leviton HXC4D-1TW specifications Product Specifications

Product

Specifications

TYPICAL SPECIFICATION

The Four-Address Wall Mounted dimming controller controls all properly addressed PLC devices that are X-10 compliant and of the appropriate type via 120 KHz signals transmitted over 120VAC, 60Hz power lines. It features Leviton’s Intellisense™ Technology (gated automatic gain control). It utilizes green LED’s that illuminate to indicate ON command sent or STATUS ON report received. It is compatible with Decora screwless and standard designer wallplates. It has available color change kits in White, Ivory and Almond.

STANDARDS COMPLIANCE

Meets all applicable standards:

Standard and Extended X-10 Code Format (XTC798) UL Listed (File #E-66800)

CSA Certified (File #LR-54628) UL 244A tested.

SPECIFICATIONS

Dimensions:	4.40” H x 1.76” W x 1.40” D
Rating:	120VAC, 60Hz
Power Consumption:	3W
Output Frequency:	120KHz

INSTALLATION CONSIDERATION

•Cat. No. HCA02-10E coupler/repeater must be installed in every DHC installation to insure maximum signal strength.

•Maximum of 4 “transmit-capable” devices (controllers, programmers and 2-way receivers) should be installed on a single branch circuit.

COMMUNICATION

Transmit:

•Address ON – when any ON button is pressed, sends command to all units with address (House code & Unit code) corresponding to the button pressed on the controller/transmitter.

•Address OFF – when any OFF button is pressed, sends command to all units with address (House code & Unit code) corresponding to the button pressed on the controller/transmitter.

•Bright – when ▲ button is pressed, brightens the last device addressed on base House Code

•Dim – when ▼ button is pressed, dims the last device addressed on base House Code

HXC4D-1TW

.............................

Receives:

•STATUS ON and STATUS OFF reports from any 2-Way capable receivers whose addresses correspond to the buttons on the controller when status of the receiver is changed manually.

COLOR CHANGE KIT ORDERING INFORMATION

Ivory	DRK4D-00I
White	DRK4D-00W
Almond	DRK4D-00A
LABEL KIT
Ivory	DCK4D-0CI
White	DCK4D-0CW
Almond	DCK4D-0CA

PROGRAMMING

Unit requires that a Base address be set using a matrix of 8 buttons located behind the easily removed color change kit. This base address, both House Code and Unit Code, determines the range of address that the transmitter can control. In this case (HXC4D) the base address will correspond to the first, top-most set of ON/OFF buttons and the next three (sequential) addresses, i.e. A1 (base), A2, and A3.

WARRANTY INFORMATION

Two year limited product warranty.

DIMENSIONAL DRAWING

				1.40
				(35.5 mm)
(112.04.40mm)		ON	OFF
	(83.33.28mm)	ON	OFF	2.69	mm)(68.2
		ON	OFF
		ON	OFF

1.761.60

(45.0 mm) (40.6 mm)

SPECIFICATION SUBMITTAL

JOB NAME:

CATALOG NUMBERS:

JOB NUMBER:

Leviton Mfg. Co., Inc.

59-25 Little Neck Pkwy • Little Neck, NY 11362-2591 • Tech Line: 1-800-824-3005 • Fax: 1-800-832-9538

2Visit our Website at: www.leviton-lin.com

B-1100/D5