LG Electronics 32LN536, 32LN536-Z, 32LN54-Z 4.2. 3D function test, 4.3. IR emitter inspection

Only for training and service purposes

* Manual W/B process using adjust Remote control.

▪ After enter Service Mode by pushing "ADJ" key,

▪ Enter White Balance by pushing "►" key at "8. White

Balance".

* CASE Cool Mode

First adjust the coordinate far away from the target

value(x, y).B.

1) x, y > target

2) x, y < target

3) x >target, y < target

4) x < target, y > target

- Every 4 case have to fit y value by adjusting B Gain

and then fit x value by adjusting R-Gain.

- In this case, increasing/decreasing of B Gain and R

Gain can be adjusted.

How to adjust

1) In case G gain more than 172

Adjust R Gain and B Gain less than 192

2) if the G gain value be adjusted down to 172

G gain increase to 172 and R gain / B gain increase

same as G gain increases.

3) if R Gain / B Gain is more than 255 , the G gain adjust

to less than 172.

* CASE Medium / Warm

First adjust the coordinate far away from the target

value(x, y).

1) x, y > target

i) Decrease the R, G.

2) x, y < target

i) First decrease the B gain,

ii) Decrease the one of the others.

3) x > target, y < target

i) First decrease B, so make y a little more than the target.

ii) Adjust x value by decreasing the R

4) x < target, y > target

i) First decrease B, so make x a little more than the target.

ii) Adjust x value by decreasing the G

* After you finished all adjustments, Press "In-start" key and

compare Tool option and Area option value with its BOM, if

it is correctly same then unplug the AC cable. If it is not

same, then correct it same with BOM and unplug AC cable.

For correct it to the model's module from factory Jig model.

* Push the "IN STOP" key after completing the function

inspection. And Mechanical Power Switch must be set

“ON”.

4.2. 3D function test

(Pattern Generator MSHG-600, MSPG-6100[Support HDMI1.4])

* HDMI mode NO. 872 , pattern No.83

(1) Please input 3D test pattern like below.

(2) When 3D OSD appear automatically , then select OK key.

(3) Don't wear a 3D Glasses, Check the picture like below.

4.3. IR emitter inspection

(1) Start 3D pattern inspection.

(2) If IR emitter signal is correctly received to IR receiver, the

lamp of IR tester turns on.

EZ ADJUST

0. Tool Option1

1. Tool Option2

2. Tool Option3

3. Tool Option4

4. Tool Option5

5. Tool Option Commercial

6. Country Group

7. Area Option

8. ADC Calibration

9. White Balance

10. 10 Point WB

11. Test Pattern

12 EDID D/L

13. Sub B/C

14. Ext. Input Adjust

Whit Balance

Color Temp. ◄ ►

R-Gain

G-Gain

B-Gain

R-Cut

G-Cut

B-Cut

Test-Pattern

Backlight

Reset To Set

Cool

172

192

100