Operating Instructions
Wireless
Remote
Controller
Controls |
|
|
|
|
|
| Signal transmitter | |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5 |
|
| 1 |
6 |
|
|
|
|
|
| 3 |
4 |
|
|
|
2 |
| CANCEL | 10 |
|
| ||
|
| 9 | |
7 | OFF | SET | |
ON | 12 | ||
11 |
| AUTO CLEAN | |
8 |
|
| 17 |
13 |
|
| 18 |
|
| 14 | |
|
|
| |
15 |
|
| 16 |
Operation Mode 
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
1. START/STOP BUTTON
Operation starts when this button is pressed and stops when the button is pressed again.
2. OPERATION MODE SELECTION BUTTON Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps low, medium, high and CHAOS.
5.JET COOL
Used to start or stop the speed cooling.
(speed cooling operates super high fan speed in cooling mode.)
6. AUTO SWING BUTTON
Used to stop or start louver movement and set the desired up/down airflow direction.
7.ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
8.TIME SETTING BUTTONS Used to adjust the time.
9.TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and to cancel the Timer operation.
10.SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
11.AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
12.ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.
13.PLASMA
Used to start or stop the
14.HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (OPTIONAL)
Used to set the desired horizontal airflow direction.
15.RESET BUTTON
Used prior to resetting time.
16.2nd F Button
Used prior to using modes printed in blue at the bottom of buttons.
17.AUTO CLEAN (OPTIONAL) Used to set Auto Clean mode.
18.˚C TO ˚F SWITCHING BUTTON
Used to switch temperature reading from Centigrade to Fahrenheit.
❈The wireless remote controller do not operate the swirl mode.
CAUTION:of handling the Remote Controller
•Aim at the signal receiver on the wired remote controller so as to operate.
•The remote control signal can be received at a distance of up to about 7m.
•Be sure that there are no obstructions between the remote controller and the signal receptor.
•Do not drop or throw the remote controller.
•Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or any other heat source.
•Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal operation. (ex:electronic quick start, ELBA, inverter type fluorescent lamp)
