Custom Master TV Setup (Cont.)

Custom Master TV Setup Procedure

1.Turn ON the TV.

If the Express Script Installer Menu Wizard appears on the screen when you turn ON the TV, exit the wizard.

2.Set Installer Menu items.

This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 21 to 30 for detailed information on all Installer Menu items.

a)Use the Installer Remote to access the PTC Installer Menu (see “Accessing the Installer Menu” on page 21 for further information).

The next step depends on whether the Express Script Installer Menu Wizard appeared when you turned ON the TV:

•If the wizard did appear, the TV is in a factory default state, and you can proceed to set Installer Menu items. Go to step (c).

•If the wizard did not appear, go to step (b).

b)Set Installer Menu item 117 FACT DEFAULT to 1 and press OK on the Installer Remote.

This clears all Installer Menu custom settings, channel lineup, etc. and restores the factory default settings. The value will change back to 0 after the PTC has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup.

c)Set Installer Menu item 003 BAND/AFC, as appropriate.

•

Broadcast: Set to 0.

•

HRC: Set to 2.

•

CATV: Set to 1 (default).

•

IRC: Set to 3.

d)Set Installer Menu item 027 HOSPITAL MODE, as appropriate, to select the speaker configuration.

e)Set any other Installer Menu items that affect your TV programming network to the required configuration. For example, enable/disable Aux inputs, set a Start Channel, etc.

If you intend to use a TLX file for cloning purposes, you may also configure Pro:Centric settings in the IP Environment Menu (accessible from the Installer Menu). See “IP Environment Setup” on pages 57 to 60 for further information. However, note that you cannot return directly to the Installer Menu from the IP Environment Menu; thus, you may wish to set all Installer Menu items as needed before you access the IP Environment Menu. Otherwise, you will need to reaccess the Installer Menu to set additional items.

f)After you have adjusted all Installer Menu item settings as required, press OK once on the Installer Remote to save your changes; then, press OK again to exit the menu.

xxLY560M PTC INSTALLER MENU

CPU-CTV

000

INSTALLER SEQ

000

 

 

 

UPN

000-000-000-000

ASIC D279

PTC

V1.00.020

CPU V3.11.00

 

 

 

Typical Installer Menu

Note: The Installer Menu header will vary depending on the TV you are setting up.

117

FACT DEFAULT

000

003

BAND/AFC

001

027

HOSPITAL MODE

254

Adjust the values for these

Installer Menu items.

Note: If an Aux input will not be used, it is advisable to disable it. After the TV setup is transferred to the PTC (see step 5), the only way to remove Aux inputs from the channel lineup, is to go to the Channel Preview/Banks Setup Menu and select Normal-Deleted.

(Continued on next page)

32

206-4261