Installer Menu (Cont.)
119 - DATA CHANNEL
Set to 0 to disable. Set from 1 to 135 to match the RF channel number that will be used by the Pro:Centric server as its data channel. *
For TVs in
Note: The Data Channel Auto Search feature is not available when the TV’s EBL is in FTG Mode. If the DATA CHANNEL value is 255 when the TV is configured for FTG Mode via EBL, DATA CHANNEL is defaulted to 0.
Data Channel Auto Search feature: When this item is set to 255 (default), once every 24 hours, the TV will initiate a search of 10 predefined channels (10, 20, 30, ... 100) and then, if necessary, perform a complete search of the RF channels (1 to 135) in an attempt to find the RF channel used by the Pro:Centric server as its data channel. If the Pro:Centric RF channel is found, the DATA CHANNEL value will be changed from 255 to match the server’s RF channel number. The time at which the Auto Search occurs depends on the setting of item 121 UPDATE TIME HR. See item 121 description for further information.
Note: Pro:Centric application updates are downloaded from the Pro:Centric server to the TV when the TV is turned ON; however, TV
Note: The Data Channel is automatically set to “253” if Media Type is set to “IP” either in the
121 - UPDATE TIME HR
Set the Wake For Update hour from 0 to 23. This item uses the
The Wake For Update feature uses a timer, based on the settings of this item and item 122 UPDATE TIME MN, to “wake” the TV to check for and, if applicable, download updates from the Pro:Centric server.
Under standard TV turn OFF/ON operating conditions (i.e., item 002 AC ON is set to 0), a Wake For Update event occurs when the TV is OFF. The Wake For Update event temporarily turns the TV ON, completes the update cycle, and then turns the TV back OFF. If item 002 AC ON is set to 2 or 3 for Instant ON, Wake For Update occurs when the TV is in its Muted ON state (i.e., the TV only appears to be OFF). The Wake for Update event initiates a TV reboot in order to start the update cycle and then, when the update cycle is complete, the TV returns to its Muted ON state.
If the TV display is ON when a Wake For Update event is due to occur, the Wake For Update will take place the next time the TV is turned OFF. See also description for item 002.
If Wake For Update is OFF, the time at which either a Data Channel Auto Search (item 119 set to 255) and/or an Instant ON update (item 002 set to 2 or 3) occurs is determined as follows: The TV will initiate the search and/or check for updates at 2:00 PM (if the TV clock is set) or at 14 hours of elapsed time from when AC power was applied (if the TV clock is not set). If the TV display is ON when Wake For Update is to occur, the Wake For Update will take place the next time the TV is turned OFF.
Note: This item is not available in the Installer Menu when item 119 DATA CHANNEL is set to 0, except when item 002 AC ON is set to 2 or 3 for Instant ON.
Note: The TV clock must be set in order for a Wake For Update event to occur at the precise time of day in accordance with item 121 and item 122 settings.
122 - UPDATE TIME MN
Set the Wake For Update minute from 0 to 59. See also description for item 121 UPDATE TIME HR above.
Note: This item is not available in the Installer Menu unless item 121 UPDATE TIME is set from 0 to 23.
Note: The TV clock must be set in order for a Wake For Update event to occur at the precise time of day in accordance with item 121 and item 122 settings.
*PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
30 |