LG Electronics 47WV30BR, 47WV30BS, 47WV30MS, 47WV30-BAAL setup guide Setting the Picture ID

MULTIVISION CONFIGURATION 27

Setting the Picture ID

Picture ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision. The set receiving the IR signal com- municates with another set via the RS232 connec- tor. Each set is identified by a Set ID. If you as- sign the Picture ID using the remote control, only displays with the same Picture ID and Set ID can be controlled remotely.

AUDIO

(RGB/DVI)

RS-232C OUT	RS-232C OUT	RS-232C OUT
RS-232C IN	RS-232C IN	RS-232C IN

REMOTE

CONTROL IN

IR Receiver

Picture ID

Off

Close

2If you press the left/right buttons or press the ON button repeatedly, the Picture ID cycles through OFF and 1 to 4.Assign the ID you want.

Picture ID

Off

Close

If you assign the Set ID to each set with multi-vision, and then assign the Picture ID using the red button on the remote control, the key command is displayed for the set with the same Set ID and Picture ID. A set with different Set IDs and Picture IDs cannot be controlled by IR signals.

Refer to the Set ID on page 46 for assigning a Set ID.

The maximum value of the Picture ID can be set in the Total Set ID menu.

Please refer to the Installation Manual for more information on the assignment of a Total Set ID.

ENGLISH

2X2 Multi-Vision (Total Set ID: 4)

Set IDs are assigned as shown in the picture.

1Press the ID On (Red) button on the remote con- trol.

BACK TILE EXIT

ID

ON OFF

NOTE

For example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be controlled by IR signals.

For each set, you can change the settings for the PICTURE, AUDIO, TIME, OPTION, NETWORK and MY MEDIA menus or the hot keys on the remote control.

If you press the ID OFF (Green) button, the Picture IDs for all sets are turned off. If you then press any button on the remote control, all sets will start working again. The Picture ID function may not work dur- ing MY MEDIA operating.