ENGLISH
15
Open the front
panel upward
Slide
Switch
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL
Open the front
panel upward
Slide
Switch
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL
Slide Switch Operation
FORCED OPERATION
Operationprocedures when the remote control can't be
used.
Openthe front panel upward and move the Slide
Switchto the Forced Operation position.
Ifyou want to stop operation, move the Slide Switch to
theAuto Restart or the Remote Control position.
Incase the power comes on again after power failure
onthe Forced Operation position, the operating
conditionsare automatically set as follows:
DuringForced Operation, the initial mode continues.
Auto restart
In case the power comes on again after a power failure,
Auto Restarting Operation is the function to operate
procedures automatically to the previous operating
conditions.
If you want to use this operation, Open the front panel
upward and move the slide switch to the Auto Restart
position.
If you do not want to use this operation, move the Slide
Switch to the Remote Control position.
Heat pump Model
CoolingModel RoomTemp. ≥24°C21°C≤RoomTemp. < 24°C RoomTemp. < 21°C
Operatingm ode Cooling Cooling HealthyDehumidification Heating
Indoor FAN Speed
High High
HealthyDehumidification Rule
High
SettingTemperature
22°C22°C23°C24°C
HELPFUL INFORMATION
Fan speed and cooling capacity.
The cooling capacity indicated in the specification is the
value when the fan speed is set to high, and the capacity will
be lower at low or medium fan speed.
High fan speed is recommended when you wish to cool the
room quickly.
High
Speed
When you are out for a while, put the
Slide Switch on the Remote Control.