INSTALLATION INSTRUCTIONS
(CONTINUED)
4.FASTEN THE SHUTOFF VALVE
Fasten the shutoff valve to the cold water pipe with the pipe clamp,
Pipe Clamp
Shutoff Valve | ||
Water Pipe | ||
|
NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts, Consult with your licensed plumber.
=TIGHTEN THE PIPE CLAMP
Tighten the clamp screws until the sealing washer begins to swell,
NOTE: Do not overtighten or you may crush
the tubing. | Washer |
Pipe Clamp | |
Clamp |
|
7.CONNECT THE TUBING TO THE VALVE
Place the compression nut and ferrule (sleeve) for copper tubing onto the end of the tubing and connect it to the shutoff valve, Make sure the tubing is fully inserted into the valve. Tighten the compression nut securely.
Packing
Nut
_rule(sleeve)
Outlet
Valve
NOTE: Commonwealth of Massachusetts Plumbing Codes 248CMR shall be adhered to. Saddle valves are illegal and use is not permitted in Massachusetts, Consult with your licensed plumber.
8.FLUSH OUT THE TUBING
Turn the main water supply on and flush out the tubing until the water is clear.
Shut the water off at the water valve after about one quart of water has been flushed through the tubing,
6.ROUTE THE TUBING
Route the tubing between the cold water line and the refrigerator.
Route the tubing through a hole drilled in the wall or floor (behind the refrigerator or adjacent base cabinet) as close to the wall as possible,
NOTE: Be sure there is sufficient extra tubing (about 8 feet coiled into 3 turns of about 10 diameter) to
allow the refrigerator to move out from the wall after installation.
30
