CONNECTING THE WATERLINE
NOTE: Water line installation is needed when the Automatic Ice Maker and/or Water Dispenser features are available on your product.
BEFORE YOU BEGIN
This water line installation is not warranted by the refrigerator or icemaker manufacturer. Follow these instructions carefully to minimize the risk of expensive water damage.
Water hammer (water banging in the pipes) in house plumbing can cause damage to refrigerator parts and lead to water leakage or flooding. Call a qualified plumber to correct water hammer before installing the water supply line to the refrigerator.
To prevent burns and product damage, do not hook up the water line to the hot water line.
If you use your refrigerator before connecting the water line, make sure the icemaker power switch is in the O (off) position.
Do not install the icemaker tubing in areas where temperatures fall below freezing.
When using any electrical device (such as a power drill) during installation, be sure the device is double- insulated or grounded in a manner to prevent the hazard of electric shock, or is
All installations must be in accordance with local plumbing code requirements.
NOTE: Wear eye protection.
WHAT YOU WILL NEED
Copper Tubing, 1/4” outer diameter to connect the refrigerator to the water supply. Be sure both ends of the tubing are cut square.
To determine how much tubing you need: measure the distance from the water valve on the back of the refrigerator to the water supply pipe. Then add 8 feet
(2.4 m). Be sure there is sufficient extra tubing (about 8 feet [2.4 m] coiled into 3 turns of about 10 [25 cm] diameter) to allow the refrigerator to move out from the wall after installation.
Be sure that the kit you select allows at least 8 feet (2.4 m) as described above.
A cold water supply .The water pressure must be between 20 and 120 p.s.i. on models without a water filter and between 40 and 120 p.s.i. on models with a water filter.
Power drill.
1/2” or adjustable
wrench .
Straight- and Phillips- blade screwdriver
Two 1/4” outer diameter
compression nuts and
2 ferrules (sleeves) to connect the copper tubing to the shutoff valve and the refrigerator water valve.
If your existing copper water line has a flared fitting at the end, you will need an adapter (available at plumbing supply stores) to
connect the water line to the refrigerator OR you can cut off the flared fitting with a tube cutterand then use a compression fitting.
Shutoff valve to connect to the cold water line. The shutoff valve should have a water inlet with a minimum inside diameter of 5/32” at
the point of connection to the
COLD WATER
INSTALLATION INSTRUCTIONS
Install the shutoff valve on the nearest frequently used drinking water line.
1. SHUTOFF THE MAIN WATER SUPPLY
Turn on the nearest faucet to relieve the pressure on the line.
2. CHOOSE THE VALVE LOCATION
Choose a location for the valve
that is easily accessible. It is best to connect into the side of a
vertical water pipe. When it is necessary to connect into a horizontal water pipe, make the connection to the top or side, rather than at the bottom, to avoid
drawing off any sediment from the water pipe.
3. DRILL THE HOLE FOR THE VALVE
Drill a 1/4” hole in the water pipe (even if using a self- piercing valve) using a
sharp bit. Remove any burrs resulting from drilling the hole in the pipe. Take care not to allow water to drain
into the drill. Failure to drill a 1/4 hole may result in reduced ice production or smaller cubes.
25
