Installation method
- Tools you will need : Phillips head "+" driver(Manual or motorized) Ø4mm drill bit for wood or steel / Level / Stud finder / Drill. You may also need an 8mm socket wrench or an 8mm drill bit for concrete.
- Installation method is described based on the LSW200B model. The actual product may differ from the picture.
1 | Fixating the mounting bracket on the TV |
If the screw will not fully tighten when using a guide spacer, recheck the assembly depth of the screw and |
refer to the technical service manual.
Guide spacer | Guide spacer |
| |
| screw |
Install the PVC washer on models 37/42/47LE53*, 37/42/47LE55*, 42/47/55LX65*, 42/47/55LX68* Install the wall mount only after attaching the PVC washer
on the back cover of the TV.
<Work procedure>
1.Check to see if the display has screws installed into the mounting holes. If so, remove those.
2.Assemble the guide spacer and the guide spacer screw in order as shown in the picture.
-Assemble the guide spacer to the set by tightening the screw.
-Tighten the screw until the set, guide spacer and the screw are fully pressing against one another.
-Use the "+" driver (Manual or motorized) when tightening the screw.
How to attach to masonry walls
2 - Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack.
Please follow the below direction.
-Check the material of the wall and the thickness of the finishing.
-When installing the product on the wooden wall, refer to page 5.
-When installing the product on wall material not designated, install the product so that each fixated location can withstand the pull out load of 70kgf (686N) and shear load of 10kgf (980N) or above.
Anchor | Wall mount screw |
a | b | c | d | e |
-Use the Ø8mm drill bit for concrete and hammer (Impact) drill.
a.Use a drill bit Ø8mm to drill a hole for the anchor location within a depth of 80mm ~ 100mm
b.Clean the drilled hole.
c.Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d.Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face upward.
e.Align the wall mount bolt to the hole and tighten it. At this time, the bolt must be tightened with torque of 45kgf/cm or above.
3How to install the wall mount <When installing on a masonry wall>
→When you separate the 8 screws on the wall mount connected to the wall bracket for use with a wooden wall, it is much easier to install the product.
A |
Separate the wall mount screw.
4
→When installing the product on a masonry wall, turn the 8 screws on the A part counterclockwise to separate the screw and bracket.
→After aligning the wall bracket to the location to install, mark the part to screw on the wall and then remove the wall bracket.
→Refer to page 4 to attach the wall bracket.
→Use a level to check whether the wall mount is level.
