Self Diagnostics Failure Code
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE | CAUSE | WHAT TO DO |
F01 | * Overcooked food | * Press Stop/Reset Pad to stop |
|
| beep. |
| * Temperature of exhausted air is too | * Unplug the oven and wait at least |
| high | 30 minutes before reconnecting. |
|
| * Wait for the oven to cool down and reset. |
|
| * If a flame is observed, do not open the |
|
| oven door. |
|
| * If normal operation does not resume, |
|
| call the service agent with the |
|
| information of failure code. |
|
|
|
* Defective sensor circuit | * Unplug the oven and wait more than | |
|
| 10 seconds before reconnecting. |
F44 | * When a pad was pressed for more than | * If normal operation does not resume, |
| 2 minutes | call the service agent with the |
| * Defective pad or control circuit | information of failure code. |
|
| |
|
|
|
NOTE: Above codes shown in the display do not indicate all the possible failures on the unit.
Care of Your Microwave Oven
1.Unplug the oven before cleaning.
2.Keep the inside of the oven clean. When food spatters or spilled liquids adhere to the oven walls, wipe with a damp paper towel. Mild detergent may be used if the oven gets very dirty. The use of harsh detergent or abrasives is not recommended.
3.The outside oven surfaces should be cleaned with a damp paper towel. To prevent damage to the operating parts inside the oven, water should not be allowed to seep into the ventilation openings.
4.If the Control Panel becomes dirty, clean it with a soft, dry cloth. Do not use harsh detergents or abrasives on the Control Panel. When cleaning the Control Panel, leave the oven door open to prevent the oven from accidentally turning on. After cleaning, press the Stop/Reset Pad to clear the display window or turn the Timer Select Dial back to zero “0” position.
5.If steam accumulates inside or around the outside of the oven door, wipe with a soft paper towel. This may occur when the microwave oven is operated under high humidity conditions and in no way indicates malfunction of the unit.
6.Clean off the grease and dust on bottom surfaces often. Use warm detergent solution.
7.This oven should only be serviced by qualified person. For maintenance and repair of the oven contact the nearest authorized dealer.
- 19 -
