LG Electronics PACKAGED TERMINAL AIR CONDITIONER/HEAT PUMP owner manual Electronic Controls

Control Locations

ElectronicControls

The controls will look like one of the following.

FAN SPEED

•Every time you push this button, it cycles through the settings as follows: {High(F2) → Low(F1) → High(F2) → Low(F1)}

E/SAVE

'F

	HEAT
	FAN	HIGH
TEMP	COOL	LOW	TIMER

MODE FAN TIMER

ON

POWER

• To turn the air conditioner ON, push this button.

To turn the air conditioner OFF, push the button

OFF

again.

• This button takes priority over any other button.

MODE

-Push this button to cycle through the modes from COOL → FAN

→HEAT→ COOL.

-COOL

•Fan runs continually for normal cooling operation.

-ENERGY SAVER

•The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air temperature to determine if cooling is needed.

-FAN

•Fan operation without heating or cooling.

-HEAT

•Fan runs continually for normal heating operation.

TIMER

- SHUT-OFF TIME

TEMPERATURE SETTING

•Use this button to automatically control the temperature of the room.

The temperature can be set within a range of 54° F to 86° F by increments of 2° F.

•The setting appears in the display.

•You will usually use shut-off time while you sleep.

•If unit is running, use Timer to set number of hours until shut-off.

•For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 minutes, and once again after another 30 minutes.

•Push Timer to cycle through the settings from 1 Hour → 2 Hours → ... → 12 Hours maximum.

14Room Air Conditioner