LG
parallel lines outside of the Sea of Mirrors (SOM).
2.9.2Exposed Metal 2
Exposed Metal 2 is due to a shift in positioning of either the die or the window aperture which may allow light to be reflected off of the layer of metal 2 that is below the super structure (mirrors). This defect is located at the outer edge of the SOM.
2.9.3Reflective Edge
Reflective Edge is light that may reflect from the edge of the DMDs window aperture onto the projection screen. It will appear as a thin diffuse line outside of the SOM.
2.10Two Zone Blue 60 Screen
The Two Zone Blue 60 screen is used to test for major dark blemishes. Refer to Figure 1 for configuration. All areas of the screen are colored a Microsoft Paintbrush blue 60 (green and red set at 0, blue set at 60).
NOTE: If linear degamma is not used then the Microsoft Paintbrush values must be adjusted to match the degamma table being used in order to generate an equivalent blue level on the test screen image.
2.11Two Zone Gray 10 Screen
The Two Zone Gray 10 screen is used to test for major light blemishes. Refer to Figure 1 for configuration. All areas of the screen are colored a Microsoft Paintbrush gray 10 (green, red, and blue set at 10).
NOTE: If linear degamma is not used then the Microsoft Paintbrush values must be adjusted to match the degamma table being used in order to generate an equivalent gray level on the test screen image.
3.ACCEPTANCE REQUIREMENTS3.1 Conditions of Acceptance
All DMD image quality defects must be determined under the following projected image test conditions:
a.Projector degamma shall be linear.
b.Projector error diffusion shall be off
c.Projector brightness and contrast settings shall be set to nominal.
d.The diagonal size of the projected image shall be a minimum of 60 inches.
e.The projection screen shall be 1X gain.
f.The projected image shall be inspected from an 8 feet minimum viewing distance.
g.The image shall be in focus during all Table 1 tests.
3.2Test Sequence
Tests shall be run in the sequence listed in Table 1.
36