11
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
4. Install a light layer of rockwool directly over the ports.
- A light layer will give a more constant rear flame.
- A heavy layer will give more glow, but will need to
be adjusted after light up.
5. Install front logs on retainer slots.
faCe installation
A number of different face finishes and styles are available
for your Ravenna gas insert. The Arch face comes with a
sight obstructor that must be installed prior to installing
the surround panels and face. Instructions for installing the
sight obstructor are included with the face. The faces come
with hooked brackets. To install the face, hang the hooked
brackets on the surround brackets (See C in Figure 13).
Note: Gold and nickel plated surfaces must be cleaned with
glass cleaner and a soft clean cloth before firing the first time
or fingerprints and stains will remin permanently. NEVER
use brass polish to clean gold or nickel surfaces, this will
remove the plating!!!
2. Install all surround panels and trim with the insert po-
sitioned in the fireplace, but a few inches in front of its
final location.
3. If an Arch face is to be installed on the insert, the sight
obstructor that comes with the face must be installed
prior to installing the surround panels. See the instruc-
tions included with the face for proper sight obstructor
installation.
4. Install the side surround panels by lining up the holes in
the tabs on the side surround panels in front of the holes
on the surround brackets. Next insert two slotted 1/4"
truss screws for each side surround panel and secure
loosely.
5. Fasten the top surround panel with the remaining two
truss screws. Tighten all six truss screws after adjusting
the surround panels to eliminate space between side and
top surround panels.
6. Assemble the surround trim by inserting the elbowed
retainer in the rectangular slot in the ends of the longest
piece of trim and secure by tightening the screw in the
retainer. Slide the mitred ends of the two side trim pieces
onto the elbowed retainer and secure by tightening the
retainer screw.
7. The fastened trim pieces should now be horseshoe shaped.
Slide the trim down over the surround panels so the edge
of the surround panel fits just behind the rounded edge
of the trim.
8. Install three spring clips (found in parts bag in firebox)
in each piece of trim by inserting them between the rear
of the surround and the channel of the trim. The spring
clips will push the trim tight to the surround.
6. Place embers around the perimeter of the rockwool.
IMPORTANT!!! Do not cover the ports with the embers.
7. Place top log on pin.
surround installation
The Ravenna™ insert surrounds are made of heavy gage
steel for durability and, if desired, for the ease of making
an inside fit in the fireplace. See Packaging List for avail-
able sizes.
1. Remove the speed nuts (A in Figure 13) from the parts
bag and install (with the flat surface forward) on the six
holes in the surround brackets - three on each side of the
insert (B in in Figure 13). A flat bladed screwdriver may
help in installing the nuts.
Figure 10
Figure 11
A
Figure 13
B
C
Spring Handle Latches
Door Mounting Plates
Figure 12
Front Logs
Top Log
Ports