Cloning Procedures (Cont.)
Teach Master STB Setup to Target STB
1.Turn ON the Target STB/display panel.
2.The next step depends on whether the
•If the wizard is displayed, the STB is in the required factory default state. To continue with this procedure (see also note below), exit the wizard, and then continue with step 3.
•If the wizard is not displayed, restore the STB to a factory default condition before continuing with this procedure. See Reference section, “Restoring Factory Defaults on the STB(s),” as necessary, for further information.
Note: If desired, you can complete the Teaching process via the EZ- Manager Wizard (see “USB Configuration” on page 22).
3.Tune/set the STB to an analog or digital channel or Aux input (ideally the same source tuned for
4.Insert the USB memory device with the TLL file into either of the USB ports on the Target STB.
5.Press MENU on the Installer Remote to display the STB setup menus. Use the arrow navigation keys to select/highlight the Option menu icon, and then press the number “7” key a total of seven times to display the USB Download Menu.
6.With the USB Download Menu on display, use the Up/Down arrow keys to select Teach To STB (TLL), and then press OK.
7.In the Teach To STB (TLL) window, use the Up/Down arrow keys to select the Master STB Setup you want to install.
Note: Filenames for TLL files Learned from an STB are comprised of the STB model and a
8.Press OK when you are ready to initiate the Teaching process.
Teaching status will be shown on a progress bar in a new window. Do NOT remove the USB device until Teaching is complete. When the Teaching process is complete, the USB Download menu will reappear on the screen.
9.When Teaching is done, press 
on the Installer Remote to exit the USB Download Menu, remove the USB memory device from the STB, and turn OFF the STB/display.
10.After a few seconds, turn ON the STB/display, and verify that the Master STB Setup is now resident on the Target STB.
When you turn it back ON, the STB will tune according to the setting of Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start Channel is specified, the STB will tune to that channel; otherwise, the STB will return to the last channel tuned.
USB Download Menu
Upgrade STB Software
Upgrade PTC Software
Diagnostics
Teach To STB (TLL)
Teach To STB (TLX)
Previous | OK |
Note: The Diagnostics option in this menu is for service use only.
Teach To STB (TLL)
Previous | OK |
!Teach To STB
UPDATING...
50%
Do not remove the USB from the port!
Do not unplug!
44 |