STB-2000 Cabling Connections (Cont.)

(Continued from previous page)

While the STB is turning ON and sending the turn ON command to the display, the STB LED blinks at a constant rate. Once both the STB and the display panel are ON, the STB LED remains lit but blinks off twice in rapid succession every five seconds. The first image you should see on the display panel is the Setting a Resolution screen from the STB (see “Setting the Video Output Resolution” on page 14).

4.Select the video output resolution (i.e, the STB’s video output format), and complete the appropriate Commercial Mode setup procedures, as described in this document.

Note: It is recommended that you complete STB-2000 Commercial Mode setup procedures before you make external equipment connections to the STB-2000.

STB-2000 Cabling Diagram

See also step 2 of procedure above.

STB-2000 Front Panel

DISPLAY

MPI

 

 

 

CONTROL 2

IN 2

IN 1

 

 

 

USB IN 2

 

 

 

 

 

 

 

 

USB IN 1

a)Connect DISPLAY CONTROL 2 to LG Hospitality display panel MPI port or to commercial non-LG TV MTI (DATA) port.*

b)Connect HDMI OUT on STB to HDMI IN on display panel.**

a)Connect DISPLAY CONTROL 1 to LG Public Display or Commercial Monitor display panel RS-232 port. *

OUT

LAN

DIGITAL

 

 

 

 

 

POWER

ANTENNA/

 

AUDIO

AUDIO

AV IN SERVICE

IR IN

DISPLAY

1

 

 

 

LINE OUT

CONTROL

 

CABLE IN

STB-2000 Rear Panel

*Only one DISPLAY CONTROL connection should be used, depending on the type of display panel to be controlled.

**The STB default configuration automatically sends Display Control commands to switch the connected display panel to its HDMI1 input.

c)& d) Complete STB Power and Antenna/Cable connections.

8

206-4256