Troubleshooting Chart
If the UPS fails to operate properly, turn off the unit and repeat the steps in the Installation section of this manual. If the problem per- sists, refer to the chart below:
Problem | Cause | Solution |
|
| Check the circuit protector on the side |
UPS will not | Overload/ | of the UPS. If it is tripped, reset it and |
restart the UPS. | ||
start | Short circuit | For further help, call your local dealer, |
|
| Liebert representative or the Liebert |
|
| Worldwide Support Group. |
| UPS not plugged in | Plug in power cord securely. |
| Circuit protector | Reset the circuit protector and restart |
| tripped | the UPS. |
| Power not available | Have the mains receptacle checked |
UPS starts | at mains receptacle | by a qualified electrician. |
on battery, | Input voltage below | Wait until the voltage rises to an |
but will not | appropriate level or have the mains | |
switch to AC | threshold | receptacle checked by a qualified |
|
| electrician. |
|
| Wait until voltage lowers to an |
| AC overvoltage | appropriate level or have the mains |
| receptacle checked by a qualified | |
|
| |
|
| electrician. |
| Overload/ | Check the circuit protector on the rear |
| Short circuit | of the UPS. If it is tripped, reset it and |
|
| restart the UPS. |
|
| |
UPS shuts |
| If the problem persists, disconnect |
| some of the equipment from your | |
down, Fault |
| |
Indicator lit | Internal UPS fault | equipment must not exceed the |
|
| capacity of the UPS. For further help, |
|
| call your local dealer, Liebert |
|
| representative or the Liebert |
|
| Worldwide Support Group. |
UPS not | Overload | Reduce load. |
providing | Battery not charged | Recharge battery. |
expected | due to a recent | |
backup time | outage |
|
16