Liebert CW038, CW146 AND CW181, CW026 Section C-C, To The Fan Wire Harness, CW051 AND CW060 MODELS

C

	C
	6	FAN MODULE
		RESTING ON FRAME
	6
7	7

"Z" BRACKETS

SECTION C-C

FAN DECK AND SIDE PANELS

NOT SHOWN IN THIS VIEW

6

6.USING THE FACTORY SUPPLIED JACK AND CRANK, LOWER THE FAN MODULE UNTIL IT RESTS ON THE FRAME OF THE UNIT. USE CAUTION TO PREVENT DAMAGE

TO THE FAN WIRE HARNESS.

7.CW026, CW038, CW041, CW076 THRU CW114 MODELS: USING THE HARDWARE REMOVED IN STEP 5, RE-INSTALL "Z" BRACKETS WITH HEX-HEAD SCREWS TO RETAIN FAN MODULE IN THE FULLY LOWERED POSITION.

CW051 AND CW060 MODELS:

USE THE HEX-HEAD SCREWS REMOVED IN STEP 5 TO SECURE THE FAN MODULE DIRECTLY TO THE CENTER FRAME SUPPORT. SCREW CLEARANCE HOLES ARE PROVIDED IN THE FAN MODULE. THE "Z" BRACKETS WILL ONLY BE USED TO SECURE THE FAN AT THE OUTTER ATTACHMENT POINT.

LIEBERT DS, CW146 AND CW181 MODELS:

USE THE HEX HEAD SCREWS REMOVED IN STEP 5 TO SECURE THE FAN MODULE DIRECTLY TO THE FRAME. SCREW CLEARANCE HOLES ARE PROVIDED IN THE FAN MODULE.

NOTE: NOT ALL HARDWARE REMOVED IN STEP 5 WILL BE USED TO RETAIN FANS IN LOWERED POSITION.

8.REPEAT STEPS 3-7 TO LOWER REMAINING FAN MODULE(S) IF PRESENT.

NOTE: THE FANS MUST BE OPERATED IN EITHER THE FULLY RAISED POSITION OR FULLY LOWERED POSITION. NO OTHER COMBINATION OF FAN POSITIONING IS SUPPORTED.

DPN002037	PAGE 2 OF 3	REV 7/10
		REV 5