Liebert Datawave Liebert Corporation, Liebert.com 24 x 7 Tech Support, Emerson Network Power

Liebert Datawave® Magnetic Synthesizer

Specifications

60Hz

			Three	Input				Heat Output
			Phase	Circuit	Panel	Dimensions		(BTU/Hr)
	Output		Input	Breaker	Board	(in)	Weight	@ Full Load
	kVA	kW	Voltage1	(Amps)	Poles2	(Wx D xH)	(lbs)	PF=1
15		15	208	60	42	36x34x64	1,200	6,350
			480	30
			600	25
20		20	208	80	42	36x34x64	1,500	8,450
			480	40
			600	30
30		30	208	125	42	36x34x64	1,600	10,125
			480	50
			600	50
50		50	208	200	84	44x32x68	2,400	12,850
			480	90
			600	70
75		75	208	300	84	44x32x68	2,750	19,270
			480	125
			600	110
100		100	208	400	120	66x36x76	3,900	25,700
			480	175
			600	150
125		125	208	500	120	66x36x76	4,300	32,100
			480	225
			600	175
150		150	208	600	120	1043x36x76	5,800	38,500
			480	250
			600	225
200		200	208	800	120	1043x36x76	6,500	51,400
			480	350
			600	300

50Hz

			Three	Input				Heat Output
			Phase	Circuit	Panel	Dimensions		(kW/Hr)
	Output		Input	Breaker	Board	(cm)	Weight	@ Full Load
	kVA	kW	Voltage4	(Amps)	Poles2	(Wx D xH)	(kg)	PF=1
15		15	380	40	42	92x87x163	590	1.85
			400	40
			415	30
20		20	380	50	42	92x87x163	730	2.47
			400	50
			415	40
30		30	380	70	42	92x87x163	775	2.97
			400	70
			415	60
50		50	380	110	84	112x81x173	1,200	3.76
			400	110
			415	100
75		75	380	175	84	112x81x173	1,375	5.65
			400	175
			415	150
100		100	380	225	120	168x92x193	2,000	7.53
			400	225
			415	200
125		125	380	300	120	168x92x193	2,230	9.41
			400	250
			415	250
150		150	380	350	120	2643x92x193	2,950	11.29
			400	350
			415	300
200		200	380	450	120	2643x92x193	3,340	15.05
			400	450
			415	400

General Specifications

Voltage Regulation: For input voltages of ±40%, output voltage is within +5% for any load condition up to full load.

Overload Capacity: Supports 200% load until circuit breaker trips, 5 to 20 minutes typical.

Output Voltage Distortion: Less than 4% total, not additive to input distortion.

Noise Suppression: 120dB common mode and 120dB normal mode.

Efficiency: 89% for 15-20 kVA, 91% for 30 kVA, and 93% for 50-200 kVA at full load.

Input Power Factor: >0.96 half to full load, regardless of load power factor.

Unbalanced Loads: Output voltage is within +5%, -2% with 100% load current unbalance.

Single Phase Protection: For loss of one input phase, output voltages remain within 6% and –4% up to 60%load.

Audible Noise: 55-63 dBa at 5 feet.

Monitored Parameters: Input and Output Voltages; Output, Neutral and Ground Currents; Output Voltage THD; Output Current THD; K-Factor, Crest Factor; Output Power kVA, kW- Hours; Power Factor; Percent Load; Frequency.

Alarm Conditions: Output Over- and Under- voltages; Output Voltage THD; Output Overload; Neutral and Ground Overcurrents; Transformer Overtemperature; Frequency Deviation; Phase Sequence Error; Phase Loss; Five Customer Specified Alarm Conditions.

Liebert Corporation

1050 Dearborn Drive

P.O. Box 29186

Columbus, Ohio 43229

800 877 9222 Phone (U.S. &

Canada Only)

614 888 0246 Phone (Outside U.S.)

614 841 6022 FAX

Via Leonardo Da Vinci 8

Zona Industriale Tognana

35028 Piove Di Sacco (PD)

Italy

39 049 9719 111 Phone

39 049 5841 257 FAX

Emerson Network Power Asia Pacific

7/F., Dah Sing Financial Centre

108 Gloucester Rd, Wanchai

Hong Kong

852 25722201 Phone

852 28029250 FAX

liebert.com

24 x 7 Tech Support

800 222 5877 Phone

614 841 6755 (outside U.S.)

While every precaution has been taken to ensure accuracy and completeness in this literature, Liebert Corporation assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions.

© 2006 Liebert Corporation. All rights reserved throughout the world. Specifications subject to change without notice.

All names referred to are trademarks or registered trademarks of their respective owners.

®Liebert and the Liebert logo are registered trademarks of the Liebert Corporation.

SL-20199 (R07/06) Printed in USA

Emerson Network Power.

The global leader in enabling Business-Critical Continuity™.

AC Power Systems

Connectivity

DC Power Systems

Embedded Computing

Embedded Power

Integrated Cabinet Solutions Outside Plant

1Other input voltages available. Standard output voltages are 208/120, 480/277, and 600/346 volts. For voltages not show, consult factory.

2Panelboards furnished on "SC" models. Main output breakers furnished on "CA" models.

3For ease in shipping and handling, unit shipped in two modules of 52 inches (132 cm) each.

4Other input voltages available. Standard output voltages are 208/120, 380/220, 400/230 and 415/240 volts. For voltages not shown, consult factory.

Power Switching & Control Precision Cooling

Services

Site Monitoring

Surge Protection

Emerson Network Power.com

Business-Critical Continuity, Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2006 Emerson Electric Co.