Liebherr 7082 344-01 manual Insertion into row of kitchen units, Top unit Refrigerator/freezer

3 kitchen unit side panel

4 wall

Instructions for installation and modification

W Re-attach the doors: Remove plugs bp from the door mounting points and re-place on the other side.

- Suspend top door in hinge pin 7 (with version I, do not forget to use spacer sleeve 9), close door.

- Slide middle hinge pin 6 into the door mounting from be- low through the hinge bm. Make sure the door is flush with the body of the appliance; adjust if necessary using the slots on the hinge.

- Suspend lower door, close.

- Rotate hinge component 4 by 180°, remove hinge pin 5, turn by 180° and replace, mind the locking facility. Mount both parts in the hinge bq: slide the pin into the door mount- ing through the hinge, tilt in the hinge component, slide up and attach with screw 3.

W Align the door flush with the body of the appliance using the slot on the hinge bq, then tighten screw 3.

W Attach the plinth panel 1 and click into place by pressing. W With the door open, insert the cover 2 in the plinth panel

at the front and click into place at the back.

W Transfer* door handles br and plugs bt. With the door open, carefully lift out the pressure plates* bs at the front and slide away; unscrew handle using a Torx® or Phillips screwdriver*.

Re-assemble in reverse order: replace the pressure plates and click into position.

Insertion into row of kitchen units

Fig. U. The appliance can be installed in a row of kitchen units. To adapt the height of the appliance to the surround-ing furniture a top unit 1 can be added.

A gap of at least 50 mm depth must be provided behind and along the entire width of this unit so as to ensure sufficient ventilation. The area of ventilation underneath the ceiling should be at least 300 cm2. The greater the area the more economically the appliance will run.

W When installing with standard kitchen units (max. depth 580 mm), the appliance can be set up right next to the kitchen unit. The door protrudes 34 mm from the side of the kitchen unit and 51 mm at the front. This enables it to be opened and closed without difficulty.

W When setting up the appliance next to a wall 4, a minimum distance of 36 mm must be provided on the hinge side between the appliance and the wall (for the handle when the door is open).

	597	631		[mm]
		614
		644
		1179
	1841
S		56,5		10
	I	II		9 Torx	25
			8	25	20
	8
8	7	8		7
	SW5
				SW5

	9	21					9
	11 12
		20	25		180°	25	20
*
10	6		9				21
13		5		14
2
		4				18 *
15		3	17*	16*

Torx15

1

13

15

GB

1 top unit

2 refrigerator/freezer

T

T1

All types and models are subject to continuous improvement and the manufacturer therefore reserves the right to make modifications in the shape, equipment and technology.

1

2

3

U4

min.		.
300 cm	2
		50
		min
631

580

ca. 36

[mm]

BN/SBN/es...6 21