SM60 Unpacking & Assembly Instructions
17
The parts shown in Hardware Figure 1 are used to assemble the SM60. They are:
A. 7/16” x 6” hex head bolt (used to bolt the tricep top beams, lat top beams, and
connecting beam to the tops of the cubes)
B. 7/16” flat washer
C. 7/16” cap washer (used on the head end of the 6” bolt so end cap will fit on the nut)
D. 7/16” hex head nut
E. 3/8” x 3” hex head bolt (used to bolt the tricep pushdown beams to the connecting
beam)
F. 3/8” x 2-3/4” hex head bolt (used for all other connections)
G. End caps (bolt covers)
H. 3/8” flat washer
J. 3/8” end cap washers (end caps snap onto them)
K. 3/8” Nyloc (locknut)
The part shown in Hardware Figure 2 is the 9/16” cable jam nut that’s used to secure the
cables to the weight stacks.
Hardware Figure 2. Cable jam nut.
M. Cable jam nut
Hardware Figure 3 shows the types of cables that are included with the SM60.
NPQHardware Figure 3. Cables.
N. Lat pulldown cables (same as tricep cable) (2)
P. Tricep cable (same as lat pulldown cables) (2)
Q. Crossover cables (ball end) (2)