TR100 / TR200
Troubleshooting
MyTread
The treadmill is designed and manufactured to be reliable and easy to use. However, if you have a problem, these troubleshooting steps may help you nd the cause.
Problem: | The console is erratic or not lighting up |
Solution: | Check to make sure that the treadmill is properly plugged in, turn the power |
| switch o and back on again and make sure the safety key is in place. If the |
| problem persists contact LifeSpan Customer Service. |
Problem: | The belt does not stay in the center of the treadmill when in use. |
Solution: | First check to make sure that the treadmill is level, then refer to the instructions in |
| this manual on how to tension and adjust the belt. |
Problem: | The treadmill motor seems strained or E1 comes up after several minutes of use. |
Solution: | The lubricating silicone that is applied to the deck and belt is wearing down and |
| the belt needs to be lubricated with silicone spray. |
Problem: | The treadmill belt slips during use. |
Solution: | The belt may need to be tensioned after a period of use. Refer to the Belt |
| Tensioning and Adjustment Section of this manual. |
Problem: | Speed does not match quick keys. Treadmill Starts at 1 and goes to 16. |
Solution: | The treadmill is set up in Metric Mode. See chart on next page for Console |
| Engineering Mode. |
Problem: | Heart Rate is erratic or not picking up. |
Solution: | Make sure your hands are moist (Aloe Vera helps). Make sure all connectors at the |
| back of the console are properly connected and no wires are damaged. |
| If wearing a chest strap make sure the batteries are good and that the electrodes |
| are moist and position properly on your chest. |
Problem: | Treadmill automaticaly pauses during workout. |
Solution: | Treadmill is not picking up Step Count. Go into Engineering Mode to turn Intelli |
| Guard o. |
Problem: | Silicon icon lights up on console. |
Solution: | Lubricate the running belt with 100% pure silicone. Then simultaneously press |
| and hold the Speed Down and Start/Stop buttons until the light turns o. |
Problem: | Maintenance icon lights up on console. |
Solution: | This light indicates a scheduled cleaning and maintenance should be done. |
| Please read the Cleaning section in this manual for details. To turn the icon |
| o press the Speed Down and the Start/Stop buttons simultaneously. |
35
