/
INSTRUCTIONSHEETNO Y
INSTRUCTIONS FOR ASSEMBLING AND INSTALLING FIXTURE IS:6590
0889
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALUNG FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assura full compliance with local codas and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retein these instructions for maintenance reference.
CAUTION: FOR WET LOCATIONS, IN
ACCORDANCE WITH UNDERWRITERS LABORATORIES REQUIREMENTS, A LINE OF CAULKING COMPOUND SUCH AS ACRYLIC LATEX OR BUTYL MUST BE PLACED AROUND THE BACK OF THE FIXTURE OR AROUND THE GASK~ IN ORDER TO SEAL OUT WATER.
1. Disassemble fixture by removing LATCH SCREW
(visible at bottom). HOUSING “hinges” up for removal. See Fig. 2.
2. Thread CROSSBAR SCREWS into UNIVERSAL
BAR. Attach UNIVERSAL BAR to OUTLET BOX using OUTLET BOX SCREWS.
3, Make connections: Black fixture lead or fixture lead without tracer mark to black supply lead; white fixture lead or fixture lead with tracer mark to white supply lead. Uninsulated wire is a GROUND WIRE and must be connected to
rounding terminal or ground wire in OUTLET 80X. Use WIRE NUTS (local hardware item). Place connections in OUTLET BOX. See Fig, 1.
4.Secure BACKPLATE by placing over CROSSBAR SCREWS and threading KNOBS tightly against BACKPLATE, BACKPLATE must be mounted with SOCKET at bottom.
5.Mount diffuser HOUSING to BACKPLATE by tilting HOUSING to insert LUG into SLOT of BACK PLATE. Swing HOUSING into position, seating against GASKET, See Fig. 2.
6.Press HOUSING into alignment against GASKET and secure with LATCH SCREW. See Fig. 2.
NOTE:
8ACKPLATECROSS6ARSCREW
7‘r-
KNOB—\ \ ~uNl”ERsAL BAR
HOUSING
e
L
| ~ BOX SCREW |
FIG. 1 |
r- ‘UG
— SLOT
— BACKPLATE
CAUTION. MAXIMUM WAlTAGE AS MARKED ON
FIXTURE MUST NOT BE SXCEEDED. | LATCH | |
~ SCREW | ||
|
J
FIG. 2
