READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1088
A0105 |
| Page 1 of 1 |
INSTALLATION PROCEDURE FOR: 1088, 1088WH, 1088GW
CAUTION: (RISK OF FIRE) FOR NON
OR WITHIN 3 INCHES OF ANY PART OF FIXTURE.
CAUTION: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S REFLECTOR
TRIMS MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
1.
2.ATTACH SOCKET CUP TO TRIM:
2a. Socket cup is attached to trims by use of socket cup | 2c. Squeeze socket cup spring legs together and insert the |
spring channels on inside of eyeball. | second leg into the channel on the opposite side of eyeball. |
2b. Align one socket cup spring leg with the channel on one side of eyeball.
2d. Push socket cup into eyeball until both socket cup spring legs hit the tab at the base of the channel.
NOTE: Spring tension should draw socket cup into position.
3.PUSH UP:
Aiming may be adjusted as necessary. For rotational adjustment remove trim from fixture housing and reposition to achieve the desired aiming.
A COMPANY