READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1184
B1104 |
| Page 1 of 1 |
INSTALLATION PROCEDURE FOR: 1184WH, 1184CD, 1084WH, 1084CD, 2084WH, 2084CD
1184WH and 1184CD for use with 1104ICX, 1103R, 1100IC, 1100AICM and 1102P1 only. 1084WH and 1084CD for use with 1004ICX, 1003R, 1000IC, 1000AICM and 1002P1 only.
2084WH and 2084CD for use with 2000IC, 2000AIC, 2003R and 2002P1 only.
CAUTION: (RISK OF FIRE) FOR
OR WITHIN 3 INCHES OF ANY PART OF FIXTURE.
CAUTION: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURER’S REFLECTOR
TRIMS MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
CAUTION: BEFORE INSTALLING REFLECTOR TO
OF
1
2GASKET INSTALLATION:
A.Align open side of gasket towards socket cup (figure A).
B.Pinch gasket and insert both edges under the reflector spring clip. (figure B).
C.Push center of gasket back into socket cup until inner diameter fits over the lamp socket and smaller thru hole in gasket sits on top of socket (figure C).
Figure AFigure BFigure C
CAUTION – DO NOT STRETCH SMALL HOLE OF GASKET OVER LAMP SOCKET.
THE GASKET MUST SIT ON TOP OF SOCKET TO PROVIDE SEAL TO LAMP.
3ROTATE ROTO-CLIPS:
Rotate (4)
Note: The short leg of the
Figure D
4 SNAP ON:
Insert gasketed socket cup into neck of reflector trim making sure spring clips of socket cup snap into slots of reflector (figure E). If reflector trim has 2 sets of slots, the upper slot is used for IC
Figure E
5PUSH UP:
Align Reflector Trim so that
Note: To remove reflector trim, turn reflector trim counterclockwise while pulling downward. Once trim is out of the ceiling, squeeze reflector spring clips until the trim disengages from socket cup. (figure G).
Replacement Gasket Available: Lightolier Catalog No. LFG356
Figure F
Figure G
A COMPANY