Lightolier 26046 Power Feed to the Connectors, Wiring the CONNECTOR-- & Fig, Ground

INSTRUCTION SHEET NO.

IS:26046

A0197 Page 2 of 2

Power Extention Connector for use with ProSpec™

Track System Only.

POWER FEED TO THE CONNECTOR(S) (continued)

DIRECT POWER FEED FROM A STRUCTURAL SURFACE--Fig 4 & Fig. 5

1.Remove the bottom cover (if required) by snapping it out of the connector. Save cover.

2.Push out hole plug.

3.Thread electrical connector into the end cap.

4.Pass conduit or cable through electrical connector and secure conduit or cable to electrical connector.

5.Form the wires to the appropriate screw terminals. Cut and strip wires and attach to the screw terminals. (See wiring section of instruction sheet).

6.Snap the bottom cover onto the connector.

WIRING THE CONNECTOR--Fig. 6 & Fig. 7

Note: Multiple circuits can be fed into the Power Extension Connector. The Connector is not polarized and can be inserted into the track in any orientation. Therefore identification of the circuits during wiring needs to be controlled by the installer or electrician. The brass screw terminals are for the hot leads, the silver screw terminals are for neutral leads, and terminals marked "GND" are for the ground. The individual circuits are arranged vertically (see diagrams).

1.Form the wires to the screw terminals, strip the insulation back 1/2".

2.Slip the wire under the terminal screw head. Tighten all screw terminals when wiring is completed.

3.Make sure stripped portion of wires are not touching each other.

4.Snap bottom cover onto the connector to cover the wires.

There are additional feed in kits (Floating Canopy, End Feed Canopy, Floating Invisible Feed, Grid Ceiling Canopy Kit, Stem Kits....) that can

be used with these connectors. See the Instruction Sheet supplied with the Feed-in Kit for detailed instructions on mounting the kit to the connector.

Power
Extention
Connector
Hole Plug		Track Unit
Fig. 4					Dead End
	Power
	Extention
End Cap	Connector
Electrical					Track Unit
Connector
(by Others)
Conduit or Cable	Bottom Cover
(by Others)
Fig. 5
Power				er Ou t	Structural
Feed	Mini Coupler or				Impediment
Power			w
	In-Line Connector	o
		P
Feed

Feed Track

Feed Track

Feed Track

or Power Extension Connector

Power		er Ou t
Feed
Power	w
	o
	P
Feed
Feed Track

			Use 12 ga. solid copper wire for
			feed connections including
Circuit 2	Circuit 1		ground.
N	N
			1
	Neutral		Circuit	2
	Terminals		Circuit
	Power
	Terminals
				.50
		Fig. 5

	Power
	Extension		Feed Track
	Connector
			or Power Extension
			Connector
Power
Feed			er Ou t
Power		w
		P
		o
Feed
Power
Extension	Plain Track
Connector	Power
	Extension		Feed Track
	Connector
			or Power Extension
			Connector

		Two wires may be
Fig. 6	Ground Terminal	attached to one
		screw terminal.

Power Extension

Connector

Fig. 7 © 1997