Lightolier 6046 instruction sheet Is, 1=1 iC L I E R“ EWAH?!!WEY%Y, Power Extension Connector

P

READAND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordanrx?with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

lNSTRUCTfON SHEET NO.

IS:6046

R0992 Page 1 of 2

POWER EXTENSION CONNECTOR

FOR USE WITH BASIC LYTESPAN@TRACK SYSTEMS ONLY.

The POWER EXTENSION CONNECTOR allows power to be jumped from one track, around or through structural obstacles, to another track unit. [t replaces the DEAD END COVER at the end of an Individual track unit or a run of track units. Power can be fed intoor removedfrom the POWER EXTENSION CONNECTOR by using any of the power feed-in kits available for Basic Lytespan. A few examples are shown here.

CAUTION:

. TURN OFF POWER AT FUSE BOX BEFORE INSTALLING

TRACK.

“ INSTRUCTIONS FOR GROUNDING PER INSTRUCTION SHEET	e		TRACK
	B		UNIT
OF THE FEED-IN KIT MUST BE FOLLOWED. FAILURE TO DO		\_
			DEAD END
SO MAY RESULT IN A HAZARDOUS CONDITION,
			COVER

~USE ONLY #12 GA. SOLID COPPER WIRE IN CONNECTORS TO

MAINTAIN PROPER RATING OF TRACK.

. OBSERVE POLARITY, WHITE (NEUTRAL) WIRE MUST BE CONNECTED TO TERMINAL MARKED “NEUT”. FAILURE TO OBSERVE POLARITY MAY RESULT IN AN ELECTRICAL HAZARD,

. DO NOT USE TRACK AS A CONDUIT SUPPORT. INDEPENDENT CONDUIT SUPPORTS (SUCH AS SUITABLE CONDUIT STRAPS) MUST BE USED TO AITACH THE CONDUIT INSTALLATION TO THE BUILDING STRUCTURE.

INSTALLING THE POWER EXTENSION CONNECTOR

1.Remove the DEAD END COVER from the track.

2.	Insert the POWER	EXTENSION	CONNECTOR	in place of the DEAD	—	SCREW
END COVER. Tighten		SCREW.
3.	Follow the instructions provided		with the power	feed-in kit being used.	POWER EXTENSION

CONNECTOR

NOTE: Power can be fed into or removed from the POWER

EXTENSION CONNECTOR by using a standard 1/2” -14 I.P.S.

ELECTRICAL CONNECTOR (not included). See Track Instruction

Sheet 1S:6020.

TRACK

UNIT

1-1<> 1=1 iC> L I E R“ EWAH?!!WEY%Y