—
—
/INSTRUCTION SHEET NO.
INSTALLATION OF PRE-WIRED QUAD TUBE POWERSPEC”
ELECTRONIC COMPACT FLUORESCENT REMODELER KITS
7218HT AND 7226HT SERIES (2 PIN QUAD TUBE) IS:7226HRM
7218HF AND 7226HF SERIES (4 PIN QUAD TUBE) RI 293 Page 1of 2
READ AND UNDER~AND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
Toassure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these Instructionsfor maintenance reference.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: WHEN USING ELECTRICAL EQUIPMENT BASIC SAFETY PRECAUTIONS MUST
ALWAYS BE OBSERVED INCLUDING THE FOLLOWING:
●TO PREVENT ELECTRICAL SHOCK, TURN OFF ELECTRICITY AT ELECTRICAL PANEL
BEFORE PROCEEDING.
●RISK OF ELECTRIC SHOCK. TO PREVENT ELECTRIC SHOCK, FOR PROPER OPERATION
AND SAFETY, THIS FIXTURE MUST BE GROUNDED.
●THIS FIXTURE IS INTENDED FOR INSTALLATION IN ACCORDANCE WITH NATIONAL
ELECTRIC CODE AND LOCAL REGULATIONS.
●TURN OFF POWER BEFORE I,AMPING AND RELAMPING.
-Donot install fixture on abranch circuit having aGround Fault Circuit Interrupter (GFCI). Typically
electronic ballasts may cause GFCI tripping.
WARNING—(RWK OF FIRE) DO NOT INSTALL INSULATIONWITHIN 3INCHES OF FMTUF?ESIDES OR
WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH AMANNER TO ENTRAP HEAT
EXISTING CONSTRUCTION
=& p~@n
FIG.AFIG. BFIG. CFIG. DFIG. EFIG. F
LCUT OPENING U. WIRE-IN Ill. AllACH J-BOX IV. AITACH V. SNARON VI. PUSH-UP
CUT OPENING (Fig. A) MOUNTING RING
Use MOUNTING RING provided as atemplate to
cut ahole in the ceiling. Use inside diameter to
scribe hole.
.WIRE-IN (Fig. B)
Wire to supply leads. (For Cable, use built-in Cable
Clamp in J-BoxJ White fixture lead to neutral supply RING
lead. B!ack fixture lead to hot (120V)supply lead.
Bare fixture wire to supply ground. Use wirenuts
(local hardware item). Place all electrical
connections in the J-BOX. Attach J-BOX COVER J-BOX
onto J-BOX.
1.ATTACH J-BOX (Fig. C & G) NA
1. Attach J-BOX PIJ4TEto ceiling by pushing NAIL LO
TAB on J-BOX PIATE into ceiling, Fig. G.
2. Push LONG LEG of NAIL CLIPS (supplied in
parts bag) into RAISED BUMP of J-BOX PIATE
and SHORT LEG into ceiling, Fig. G.
3. Make sure that the J-BOX PLATE is securely
attached to the ceiling and the J-BOX is in the OPENING IN CEILING
position shown in Fig. G. FIG. G
1- I<*HTC> LBE1?”;?t;Z;f;,N2;;;l;,EZ;;Y