![IS:83ED17](/images/new-backgrounds/41084/410843x1.webp)
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE.
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:83ED17
C0104 | Page 2 of 2 |
INSTRUCTIONS FOR ATTACHING 83ED17R SERIES REFLECTORS TO
ED17 HID LYTESPOTS SERIES LUMINAIRES.
INSTRUCTIONS FOR ATTACHING 83ED17R SERIES REFLECTORS TO AN HID ED17 LYTESPOT LUMINAIRE:
(See chart below for compatible luminaires)COMPATIBLE LUMINAIRES
| Cat. No. | Product Group |
| Description | ||
| 8387 |
|
| ED17 50W Magnetic HID Lytespot |
| |
| 8387E |
|
| ED17 50W Electronic HID Lytespot | ||
| 8388 | Lytespan Track |
| ED17 70W Magnetic HID Lytespot | ||
| 8388E |
|
| ED17 70W Electronic HID Lytespot |
| |
| 8389E |
|
| ED17 100W Electronic HID Lytespot | ||
| PDE17 Series | Calculite |
| ED17 HID | ||
|
|
|
|
|
| |
| SRE17 Series |
| ED17 HID | |||
|
|
| ||||
|
|
|
|
|
|
|
ACCESS | ED17 LYTESPOT |
KNOB |
|
CUP
REFLECTOR
SPRINGSACCESSORY CARTRIDGENOTE: Reflectors must be installed prior to lamps. After reflector is assem- bled, see IS:8387 for Lytespot installation, lamping, accessory, and operating instructions.
LIP
Fig. 1
1.If Lytespot is already attached onto a track, make sure power to the track is turned off before proceeding.(Lytespan Track luminaire is shown in Figs. 1 & 2. Instructions
2.Holding ACCESSORY CARTRIDGE, loosen ACCESS KNOB a few turns until ACCESSORY CARTRIDGE opens. SWING the CARTRIDGE open
for access to REFLECTOR CUP (See Fig. 1).
3. Holding REFLECTOR by the LIP, push REFLECTOR into REFLECTOR CUP until REFLECTOR SPRINGS engage (See Fig. 2)
4.Rotate REFLECTOR clockwise until the REFLECTOR SPRINGS hit the ROTATION STOPS on the REFLECTOR CUP (See fig. 2).
To remove REFLECTOR, remove lamp, rotate REFLECTOR
REMOVAL SLOTS. Pull REFLECTOR out of REFLECTOR CUPREFLECTOR (See fig. 2).
Fig. 2
SLOT ROTATION STOP
REFLECTOR
SPRINGS
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720