Lightolier 8603 instruction sheet Is, A0300, Instructions For Assembly And Installation Of

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:8603

A0300 Page 1of 2

INSTRUCTIONS FOR ASSEMBLY AND INSTALLATION OF

RECESSED POWER JACK REMODELER KIT

WARNING: (RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF THE POWER JACK OR ITS WIRING COMPARTMENT, NOR IN SUCH A WAY AS TO ENTRAP HEAT ABOVE THE UNIT.

This unit is available in 20-50 watt versions (AND IS FOR CEILING OR WALL INSTALLATION ONLY.

A. FRAME-IN:

Fig. 1

ADJUSTABLE MOUNTING BAR

J-BOX

1.Fasten the MOUNTING FRAME to the wood joist. Line up the bottom edge of the ADJUSTABLE MOUNTING BAR with the bottom of the wood joist (Fig.1).

2.Wire to supply leads in J-BOX using wire nuts (not included).

MOUNTING

FRAME

FLANGE

LINE UP BOTTOM EDGE WITH BOTTOM OF WOOD JOIST

NOTE: ADJUSTABLE MOUNTING BARS can be extended to 24”. When mounting to suspended ceilings, make certain that the bottom of the MOUNTING FRAME is 1” or less above finished ceiling.(Fig.2)

B. CLOSE-IN:

3.Install the plasterboard or other dry type ceiling or wall.

4.Cut a 3 11/16” dia. hole in the board using the MOUNTING FRAME hole as a cutting guide.

C. MOUNTING THE JACK ASSEMBLY.

5.Slide UPPER PLATE of JACK ASSEMBLY through hole in ceiling or wall and then center plate on hole (FIg. 3 & 4).

6.Hold the BOTTOM PLATE up against the ceiling or wall and turn long SCREWS until ceiling or wall is firmly clamped between UPPER and LOWER PLATES (Fig. 5).

7.Snap the CANOPY onto the FLANGE.

NOTE: Unscrew STEM BUSHING when used with fixtures that have a screw-in adapter (Fig. 5).

USE ONLY WITH JACKS MANUFACTURED BY LIGHTOLIER. USE OF OTHER EQUIPMENT VOIDS WARRANTY AND MAY CREATE A HAZARD.

STEM BUSHING

NAILING TAB

Fig. 2

1” MAX.

1

JACK ASSEMBLY

POSITION NAILING TABS OF ADJUSTABLE MOUNTING BAR ON TOP OF T-BAR FOR PROPER SPACING TO FINISHED CEILING OR WALL

T-BAR ANCHOR CLIPS ACCESSORY NO. 1956 (ORDER SEPARATELY) CAN BE USED FOR QUICK MOUNTING.

ADJUSTABLE MOUNTING BAR

T-BAR

MOUNTING FRAME

Fig. 3

2

UPPER PLATE

Fig. 4

Fig. 5

CANOPY

STEM BUSHING

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720 2000